Confirming Via!Dj Network Connection - Elan VIA! dj 4 Installation Manual

4 output digital music server

Hide thumbs

Table Of Contents

Table of Contents

E L A N

H O M E

S Y S T E M S

If the PC is 192.168.1.100, then the VIA!dj will be 192.168.1.XXX, where X can be any

number not already in use on the home network.

9. Press

OK when done.

Note: If there is a DHCP server in the network but you are required to set the

VIA!dj's Ethernet settings manually for some reason, it is important that the last

number of the VIA!dj's IP address is not within the range of the DHCP server.

The DHCP server's range can be determined by going into the setup configura-

tion for the particular device. (see the Installation Manual for your router)

10. From the Manual Ethernet Settings menu, highlight IP Mask and press

11. Using the remote and/or front panel grid, set the IP Mask to the same number as the

Subnet Mask obtained from the PC.

12. Press

OK when done.

13. From the Manual Ethernet Settings menu, highlight Gateway and press

14. Using the remote and/or front panel grid, set the Gateway to the same number as the

Default Gateway obtained from the PC.

15. Press

OK when done.

16. From the Manual Ethernet Settings menu, highlight IP DNS 1 and press

17. Using the remote and/or front panel grid, set the IP DNS 1 numbers to the same ones as

the DNS Server obtained from the PC.

18. Press

OK when done.

NOTE: Depending on the customers ISP, there may only be one DNS Server number

available. This is normal and should not cause any problems.

19. Repeat steps 15, 16 and 17 for IP DNS 2 if available.