Model Tech Mini Mach Racer Assembly Instructions Manual page 14

High speed electronic-powered delta wing
Table of Contents

Advertisement

sTeP 3: iNsTalliNg The flighT baTTery
STEP 4: inSTALLinG ThE cAnoPY AnD ThE hATch covER
q When satisfied with the alignment, glue the canopy to the hatch cover, using a thin layer of Formula 560 Canopy Glue.
PRO TIP To enhance the appearance, apply a strip of 1/4" (6mm) wide black striping tape around the base of the canopy.
q Install the hatch cover onto the wing, making sure that the magnets hold the back of the hatch cover firmly in place.
sTeP 5: iNsTalliNg The ProPeller
q Carefully solder matching plugs onto the two battery wires on your battery
and the two battery wires on your ESC.
q Mount your flight battery to the front of the radio compartment floor, using
the strip of hook and loop material provided.
IMPORTANT The final location that the flight battery is mounted in will
depend on where the aircraft balances, as described in the next section.
q Carefully cut out the canopy along the moulded scribe line, then sand the
edges of the canopy smooth.
q Set the canopy onto the hatch cover and align it. When aligned properly,
the sides of the canopy should be centred between the sides of the hatch cover
and the front of the canopy should be approximately 3/8" (10mm) behind the
front of the hatch cover.
IMPORTANT To make sure that the motor can't accidentally be turned on
while you're installing your propeller, unplug the flight battery from the ESC
before installing the propeller.
q Install your propeller onto your motor, making sure that it's securely in place
and doesn't touch the front of the cowling.
q Cut away the covering material from over the air exit hole in the back of the
radio compartment.
Page 

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mini Mach Racer and is the answer not in the manual?

Table of Contents