Changing A Wheel - Taking Out Spare Wheel; Changing A Wheel - Installing Wheel - Volvo XC60 Owner's Manual

09 Wheels and tires
09
Changing a wheel – taking out spare
wheel
The following procedure explains how to
access the spare wheel (where applicable).
1. Open the floor hatch.
2. Undo the retaining bolt.
3. Lift out the foam block.
4. Lift out the spare wheel.
The other two blocks can remain in the spare
wheel well.
After use
The foam block and spare wheel must be
replaced in the reverse order. Note the arrow
on the upper foam block. It should point for-
ward.
292
Changing a wheel – installing wheel
It is important to re-install wheels properly.
Re-installing the wheel
1. Clean the contact surfaces on the wheel
and hub.
2. Lift the wheel and place it on the hub.
Tighten the wheel nuts
3. Install the wheel nuts and tighten hand-
tight. Using the lug wrench, tighten cross-
wise until all nuts are snug.
4. Lower the vehicle to the ground and alter-
nately tighten the bolts crosswise to
103 ft. lbs. (140 Nm).
5. Install the wheel cover (where applicable).
The opening in the wheel cover for the
tire's inflation valve must be positioned
over the valve.
Related information
•
Changing a wheel – spare wheel (p. 291)
•
Changing a wheel – removing wheel
(p. 288)