In Case Of Difficulty - Kenwood DPC-X937 Instruction Manual

Kenwood portable cd player user manual
Table of Contents

Advertisement

In case of difficulty

What seems to be a serious trouble may sometimes be due to a simple mistake. Before calling for service, check the items
shown in the following table again. (If you request servicing due to the reasons shown in the table, the service may be
charged in some cases.)
Symptom
Pressing a key cannot
initiate an operation or
turn the unit on.
No sound is heard from
the headphones.
Audio is not output from
the speakers on the
recharger stand. (DPC-
X937/DPC-X637 only)
Sound skips, or is
interrupted.
Cause
÷ The HOLD switch is set to on.
÷ The batteries are exhausted.
÷ The disc is placed upside down.
÷ Condensation has occurred inside the unit.
÷ The AC adaptor or car battery adaptor is discon-
nected.
÷ The headphones are connected incompletely.
÷ The headphones are connected to LINE OUT
(OPTICAL) jack. (DPC-X937 only)
÷ The volume is set to the minimum position on the unit.
÷ The digital connection is present. (DPC-X937 only)
÷ The main unit is placed incorrectly on the re-
charger stand.
÷ The volume is minimized on the main unit or re-
mote control.
÷ The SHOCK GUARD is set to "S.G. Lo".
(DPC-X937 Only)
÷ A strong vibration that exceeds the capacity of the
SHOCK GUARD has occurred.
÷ The disc is dirty.
÷ The headphone plug is dirty.
÷ The batteries are low.
Remedy
÷ Set the switch to off. (Page 18)
÷ Replace the two alkaline batteries, or recharge
the rechargeable batteries.
÷ Place the disc with the labeled side up.
÷ Leave the unit for about 1 hour before re-use.
÷ Connect it properly.
÷ Insert the plug securely into the
phones/ Remote control unit) jack.
÷ Insert the plug securely into the
phones/ Remote control unit) jack.
÷ Adjust the volume on the unit.
÷ When the digital connection is present, the
(Headphones/ Remote control unit) jack of the unit
does not output audio signal.
÷ Place the main unit correctly.
÷ Adjust the volume properly on the main unit and
remote control.
÷ Set the SHOCK GUARD to "S.G. HI". (page 35)
÷ Place the unit in a place not subject to vibration.
÷ Clean it.
÷ Clean it.
÷ Replace or recharge the batteries.
(Head-
(Head-
41

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dpc-x637Dpc-x537

Table of Contents