Kenwood DPC-X337 Instruction Manual

Part names
Unit Display
Program mode indicator
Å
ı Track number display
Ï
Ç Ì
‰
Î
ø
Ó ¬ Ô  Ò ˜ ˆ
Å D.A.S.C.(Digital Anti Shock Ï PLAY/PAUSE 38 (Play/Pause) key
Ì STOP 7 (Stop/Off) key
Circuit) key
ı P.MODE (Play mode) key Ó OPEN switch
Ç PROGRAM key (Slide to open top cover)
Î Display ¬ HOLD switch
‰ SKIP/SEARCH 4, ¢ Ô B.BOOST (Bass Boost) key
 VOLUME control knob
(Skip/Search) keys
Sound skip guard function (D.A.S.C.) In case of difficulty
What seems to be a serious trouble may sometimes be due to a simple mistake. Before calling for
D.A.S.C. (Digital Anti Shock Circuit)
service, check the items shown in the following table again. (If you request servicing due to the
reasons shown in the table, the service may be charged in some cases.)
When the D.A.S.C. function is operating, about a 180 seconds portion of
signals is always stored in memory. Consequently, when the unit re-
Symptom
ceives an impact, playback will continue without interruption even if the
Pressing a key
signal from the light pickup is interrupted.
cannot initiate an
"Wide CAPTURE" uses a method strong in regard to vibrations in the ro-
operation or turn
tation direction in addition to the conventional D.A.S.C. function, so that
the unit on.
the sound skip guard function is made even stronger.
Mechanism of D.A.S.C.
No sound is heard
from the head-
Storage of digital data
phones.
Digital memory
Reproduced
sound
Sound skips, or is
Setting the D.A.S.C.
interrupted.
The mode changes each time the D.A.S.C. key is pressed.
1 D.A.S.C. off
There is no data compression, so
that listening with high sound
quality is possible.
2 D.A.S.C. on : 180 seconds
Noise interferes.
Data are held for about 180 seconds.
Turn on D.A.S.C. when moving the
player or using it in areas subject to
vibration.
÷ Depending on the extent of the impact, the data in the memory
Rechargeable
batteries cannot be
may be used up, so the playback skip protection may momentarily
recharged.
be ineffective.
÷ When the D.A.S.C. function is activated, the disc may stop or start
Note :
1. This system uses a microcomputer so it may malfunction due to external noise or interfer-
to rotate.
ence. In such a case, unplug the power cord and remove the batteries, then re-connect the
÷ The reproduced sound is interrupted during switching.
power cord and insert the batteries again.
÷ The D.A.S.C. is set to on when the power turns on.
2. Erroneous operation may occur when the headphone plug is plugged or unplugged; but this
is not a malfunction.
Specifications
Format System ........................................................... Compact disc digital audio system
Laser ..................................................................................... Semiconductor laser
Audio Frequency response ........................................................ 20 Hz to 20 kHz, ± 3 dB
PHONES output level (32Ω, 1 kHz ) ............................................... 9 mW + 9 mW
Line output/impedance (BASS BOOST on) .............................. 0.48 Vrms/47 kΩ
Power supply
Repeat mode indicator
External DC supply ................................................................................. DC 4.5 V
Ramdom mode indicator Rechargeable batteries (NB-3A70) x 2 ................................................. DC 2.4 V
Commercially-available alkaline batteries (LR03) x 2 ........................ DC 3.0 V
Intoro scan indicator
Battery life (Fully charge)
Rechargeable batteries (NB-3A70)
Battery duration
Commercially-available alkaline
indicator
batteries (LR03)
÷ At 0.1mW+0.1mW output (32Ω load).
÷ Standard value during continuous use/charging in an temperature of 20˚C.
÷ Time of use may vary depending on battery maker, battery type, use environ-
Playng time display D.A.S.C. mode indicator
ment, and temperatute.
Dimensions (W x H x D) ................. 137 mm x 20.5 mm x 137 mm (5- 3/8" x 13/16" x 5-3/8")
Weight (net) ........................................................................................................ 171 g (6.0 oz)
Note:
KENWOOD follows a policy of continuous advancements in development. For this reason
specifications may be changed without notice.
Accessories
AC adaptor
Rechargeable Batteries
Ò LINE OUT jack Headphones
˜ PHONES jack
Separately sold option part
ˆ DC IN (External power) jack
Rechargeable Nickel Metal Hydride Battery ................................................................ NB-3A70
Ø IND. (Battery charge) indicator
Maintenance
Simple care
Care of lens
When the lens in the pick-up gets dirty, malfunctions in-
Cause Remedy
cluding the impossibility of playback may occur. The lens
÷ The HOLD switch is set to on ÷ Set the switch to off (HOLD
should be cleaned using a commercially available cam-
(HOLD On). Off).
era lens blower, etc. Do not touch the lens to prevent
÷ The batteries are exhausted. ÷ Replace the two alkaline batter-
damaging the mechanism. Also do not use a lens cleaner
ies, or recharge the recharge-
able batteries. or disc cleaner product.
÷ The disc is placed upside down. ÷ Place the disc with the labeled
side up.
÷ Condensation has occurred in- ÷ Leave the unit for about 1 hour Care of main unit
side the unit. before re-use. When the unit gets dirty, clean with a soft, dry cloth. If
÷ The AC adaptor is disconnected. ÷ Connect it properly.
the unit is stained seriously, a moistened cloth can be used. Do not use thinner,
÷ The headphones are connected ÷ Insert the plug securely into the benzine, alcohol, etc. for these agents may cause discoloration.
incompletely. PHONES jack.
÷ The headphones are connected ÷ Insert the plug securely into the
Cleaning the plug
to LINE OUT jack PHONES jack.
÷ The volume is set to the mini- ÷ Adjust the volume on the unit.
Wipe the headphone plug with a soft cloth to keep it clean.
mum position on the unit.
A dirty plug may cause noise or malfunction.
÷ The D.A.S.C. is set to off. ÷ The D.A.S.C. is set to on.
÷ A strong vibration that exceeds the ÷ Place the unit in a place not sub-
Caution on disc used
capacity of the D.A.S.C. has occurred. ject to vibration.
÷ The disc is dirty. ÷ Clean it. Usable discs
÷ The lens is dirty. ÷ The lens should be cleaned us-
This unit is capable of playing back the Audio CD discs, CD-R/CD-RW (CD-DA)
ing a commercially available
camera lens blower. discs and discs carrying the
÷ The headphone plug is dirty. ÷ Clean it.
single CDs can be played as they are; do not use a commercially-available single
÷ The batteries are low. ÷ Replace or recharge the batteries.
CD adapter.
÷ The headphone plug is dirty. ÷ Clean it.
÷ Certain CD-R/CD-RW discs may not be played due to recording conditions of
÷ The batteries are low. ÷ Replace or recharge the batteries.
÷ The headphones are connected ÷ Insert the plug securely into the the discs.
incompletely. PHONES jack.
÷ A source of strong magnetism or ÷ Install the unit away from a TV
Handling
radio wave, such as a TV set or cel- set, cellular phone, etc.
Hold compact discs so that you do not touch the playing surface.
lular phone, is present near the unit.
Do not attach paper or tape to either the playing side or the label side of compact
÷ Commercially available recharge- ÷ Use the exclusive rechargeable
discs.
able batteries are used. batteries (NB-3A70).
Never play a cracked or warped disc.
During playback, the disc rotates at high speed in the player. Therefore, to avoid
danger, never use a cracked or deformed disc or a disc repaired with tape or
adhesive agent.
PORTABLE CD PLAYER
DPC-X337
INSTRUCTION MANUAL
D.A.S.C. On D.A.S.C. Off
Approx. 6.5 Hours Approx. 5 Hours
Approx. 10 Hours Approx. 6.5 Hours
Before using the rechargeable batteries:
(For Europe)
÷ The rechargeable batteries comes non-charged condition.
Read "Rechargeable battery operation" carefully and charge
For Europe For other countries
the batteries before use.
1 —
2 —
Unpacking
1 1
Unpack the unit carefully and make sure that all the accessories are
present.
If any accessories are missing, or if the unit is damaged or fails to oper-
ate, notify your dealer immediately. If the unit was shipped to you di-
rectly, notify your shipper immediately. Kenwood recommends that you
retain the original carton and packing materials in case you need to move
or ship the unit in the future.
Keep this manual handy for future reference.
For your records
Record the serial number, found on the back of the unit,
in the spaces designated on the warranty card, and in the
space provided below. Refer to the model and serial num-
bers whenever you call upon your dealer for information
or service on this product.
Model Serial Number B60-5389-08 00 (E,M) AP
Cleaning
If fingerprints or foreign matter become at-
tached to the disc, lightly wipe the disc with a
soft cotton cloth (or similar) from the center of
the disc outwards in a radial manner.
Storage
When a disc is not to be played for a long period of time, remove it from the CD
player and store it in its case.
Precaution against condensation
Immediately after a room is heated or in a room with high humidity (or va-
por), the unit may malfunction due to the condensation of dew or mist on
the pick-up lens. In such a case, leave the unit for about an hour before
trying to use it again.
marking. Other discs cannot be played. 8 cm
The marking of products using lasers (For countries other than U.S.A.,
U.S.-Military and Canada)
The marking this product has been classified as Class 1. It means
CLASS 1
that there is no danger of hazardous radiation outside the product.
LASER PRODUCT
Location: Back panel
Safety precautions
Caution : Read this page carefully to ensure safe operation.
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT SAFEGUARDS
Please read all of the safety and operating instructions before operating this appliance. Adhere to all warnings on the appliance and in the instruction
manual. Follow all the safety and operating instructions. These safety and operating instructions should be retained for future reference.
1. Power sources — The appliance should be connected to a power supply only of the
type described in the instruction manual or as marked on the appliance.
2. Power-cord protection — Power-supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them, pay
particular attention to cords at plugs, convenience receptacles, and the point where
they exit from the appliance.
3. Enclosure removal —Never remove the enclosure. If the internal parts are touched
accidentally, a serious electric shock might occur.
4. Drop — Do not drop the appliance or apply strong shock to it. (Damage due to
dropping the appliance is not covered by the warranty.)
5. Ventilation — Avoid hindering the ventilation of the appliance by covering it with a
cloth, etc.
6. Abnormal smell — If an abnormal smell or smoke is detected, immediately turn
the power OFF and pull out the power cord. Contact your dealer or nearest service
center.
7. Heat — Avoid placing the appliance under direct sunlight or near a source of heat
such as heating equipment. Particularly, never leave it in an automobile or on the
dashboard.
8. Temperature — The appliance may not function properly if used at extremely low,
or freezing temperatures. The ideal ambient temperature is above +5°C (41°F).
9. Water and moisture — The appliance shall not be exposed to dripping and splash-
ing - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet
basement, or near a swimming pool, etc.
10.Dust and moisture — Avoid places where is dusty or where the humidity is high.
11.Vibrations — Avoid placing the appliance on an unstable place such as a shelf or in
0302 a place subject to vibrations.
12.Magnetic fields — Keep the appliance away from sources of magnetic fields such
as TV sets, speaker systems, radios, motorized toys or magnetized objects.
13.Cleaning — Unplug this appliance from the wall outlet before cleaning. Do not
use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. to
clean the cabinet. Use a clean dry cloth.
14.Nonuse periods — The power cord of the appliance should be unplugged from
the outlet when left unused for a long period of time.
15.Damage requiring service — The appliance should be serviced by qualified
service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally by following the instruc-
tion manual. Adjust only those controls that are covered by the instruction
manual as an improper adjustment of other controls may result in damage
and will often require extensive work by a qualified technician to restore the
appliance to its normal operation.
E. The appliance has been dropped, or the enclosure damaged.
F. The appliance exhibits a marked change in performance.
16.Servicing — The user should not attempt to service the appliance beyond that
described in the instruction manual. All other servicing should be referred to
qualified service personnel.
17.CAUTION — TO PREVENT ELECTRIC SHOCK DO NOT USE THE AC PLUG
WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
DPC-X337 (EN)