Table of Contents
Advertisement
In case of difficulty
What seems to be a serious trouble is often due to simple mistake. in case of trouble,
check it again by referring to the table below.
Note that servicing may be charged if it is requested based on the following symptoms.
Operation does not occur
when an operation key is
pressed.
No sound is output
through headphones.
Sound skips or interrupts.
Notes;
1, This system is microprocessor-controlled, so malfunction may occur due to external noise or interference
noise. In such a case, unplug the power cord, plug it and turn power on again.
2. Do not use contact cleaners because it could cause a malfunction, Be specially careful against contact
26
cleaners containing oil, for they may deform the plastic components.
(En)
@The
HOLD/RESUME
switch on
tha main
unit or remote
control
unit is in the HOLD position,
@ The batteries are exhausted.
@ The disc is placed upside down.
@ Dew is condensed inside the unit.
@The AC adapter ts disconnected.
@The
headphones
plug is con-
nected incompletely.
@The volume control of the main
unit or remote control unit is set
in a low position.
@ The unit is used in a place subject
to large vibrations.
@ Fhe disc is dirty.
@ The internal lens is dirty.
@® The headphones plug is dirty.
@ The batteries are exhausted.
@ Set to other position than HOLD.
@ Replace both of the two alkaline
batteries, or recharge the rechar-
geable batteries.
@ Place the disc with the label side
facing upward.
@ Leave the unit for about an hour
before use.
@ Connect it properly.
@ Insert it securaly into the PHONES
jack.
@ Adjust the volume control cf the
main unit or remote contro! unit.
@ Place the unit in a place subject
to small vibrations.
@ Clean it.
@ Clean it.
@ Clean it.
@ Recharge or replace them.
Advertisement
Table of Contents
