Advertisement
Chapter 2. Installation and Video Check
2.1 Installation
On the assumption that User PC and the camera are used under static IP, and
the camera is to be directly connected with User PC or Local Network.
The installation procedure is to be;
1) Connect the camera and PC with LAN Cable.
2) Power on camera.
※Use regulated 12V DC 500㎃ or 1A (Built-in IR LED Model)
※Use PoE(Power Over Ethernet) : The cable includes data and power, so it's
easy to install the camera. So, you can save time to install and cost. When you
connect the camera with PoE and DC adaptor, Only PoE is used.
3) Wait about 2 minute after power on camera, the system will be booted.
2.2 Network Setting and Video Check
Default network setting value of the unit is to be;.
IP Address
: 192.168.1.30
Subnet Mask : 255.255.255.0
Gateway
: 192.168.1.1
T o connect the unit in user's PC, change the setting value of PC network environment.
<Caution> Before changing the setting value, please memorize the previous setting
on your PC.
value
9
※The specification is subject to change without any prior notice to improve the quality.
2.2.1 Change the setting value of PC network environment
Set IP Address, Subnet Mask and Gate-way of user's PC with 192.168.1.50 /
255.255.255.0 / 192.168.1.1 as shown on below picture.
2.2.2 Connect the camera with web browser
Run web browser and input the default IP address(192.168.1.30) in URL line
and press "Enter". Then, below picture is to be shown.
※If the page does not open, Please refer to "Chapter 11 appendix" in the CD.
10
2.2.3 Input ID/Password
Shown the main page, input ID and Password and click on "Viewer" to see the
video feed.(Default administrator's ID &Password is 'admin'.)
<Caution>
Please change default value of ID/Password into new ones after the
installation.
[Reference]
Please refer to 5.3 Administrator's ID and Password Change regarding
'Change Administrator'.
2.2.4 Active-X auto installation
Click "install" on the security certificate to load the Active-X control.
If you choose "Don't install", the web viewer would not work.
①
②
③
11
2.2.5 Complete the installation
Upon installation, Web Viewer appears and image of camera is to be seen.
⑦
⑧
⑨
⑩
①
②
③
④
⑤
⑥
11
Item
Description
Select stream codec and resolution menu related to
①Stream selection
live-view was defined only by the admin.
(H.264/MPEG/MJPEG)
Default size is 640X480.
②Window size
Adjust the screen to the optimal size(Recommendation :
Select the same size with stream resolution)
③Connection/Disconnection
Connect or disconnect to the stream
④Recording
Saves the stream as a moving picture file in the .avi format
⑤Capture
Saves the snapshot as an image file in the .bmp format
⑥Saving path
Specify the file saving path
⑦Camera name
Display camera title
⑧Date
Display the date
⑨Time
Display current time
Display the site information such as Day/Night, Motion,
⑩Status Icon
Alarm input/output
Display the stream information such as Audio and
⑪Stream Info.
recording condition
12
3B25755A
Advertisement
