Table of Contents
Advertisement
the server IP. Any PC that was used for a virtual server must have a static or reserved IP
Address because its IP Address may be changed when using the DHCP function.
Service Port - The numbers of External Ports. You can type a service port or a range of
service ports (in XXX – YYY format, XXX is the start port number, YYY is the end port
number).
IP Address - The IP Address of the PC providing the service application.
Protocol - The protocol used for this application, either TCP, UDP, or All (all protocols
supported by the Router).
Status - The status of this entry either Enabled or Disabled.
To setup a virtual server entry:
Click the Add New... button.
1.
2.
Select the service you want to use from the Common Service Port list. If the Common
Service Port list does not have the service that you want to use, type the number of the
service port or service port range in the Service Port box.
3.
Type the IP Address of the computer in the IP Address box.
4.
Select the protocol used for this application, either TCP or UDP, or All.
5.
Select the Enable check box to enable the virtual server.
6.
Click the Save button.
Figure 4-35 Virtual Servers
-57-
4G Wireless-N Router
iB-W4GX150N
Advertisement
Table of Contents
