Panasonic CS-RE9PKE-3 Service Manual page 39

Removal Procedure for Main Electronic Controller
1. After front grille is taking off, remove the cover of control board and holder, then the Main PCB can be seen.
2.Drag out the supporting hook to the right side and pull up a bit the main PCB. Then release the lead wire
connecting to CN-FM, CN-STM3, earth wire (Yellow/Green) on main PCB, take out the sensor from the holder on
evaporator, release the CN1 connector on indicator PCB, pull out the whole electronic controller. Be sure to avoid
cracking of the supporting hook.
CN-FM: Fan motor connector
3. Remove the control board complete
Loose the screws of control board complete, then the whole control board can be pulled out.
Removal Procedure for Main Electronic Controller
1. Separate the drain hose and the drain plate.
Control board cover
Supporting
Hook
Holder
Indicator & receiver
Auto OFF/ON
switch
2. Pull out the discharge grille slightly.
39
CN-STM3: Air swing motor connector
CN-TH: Sensor connector
CN1: Indicator connector
Main PCB