6.
Remove the screw from the front mount-
ing panel.
Front Mounting Panel Screw
7.
Bend the metal tab back, then slide the
two rear mounting panel tabs toward the
right side, and lower them through the
cutouts in the chassis.
Rear Mounting Panel Tabs
Bend Metal Tab Back
Lower The Rear Panel
8.
Disconnect the two filament wires from the
magnetron terminals.
9.
Remove the four mounting screws from
the magnetron. NOTE: Pull the front mount-
ing panel forward so you can access the
two front screws.
REASSEMBLY NOTE: When you reinstall the
magnetron, insert the alignment pins into their
holes at the back of the magnetron.
Magnetron
Screw (1 of 4)
Front Panel
4-23
Filament Wires