WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1.
Unplug the microwave oven or disconnect
the power.
2.
Remove the air grille from the unit (see
page 4-11 for the procedure).
3.
Remove the cabinet (see page 4-2 for the
procedure).
4.
Remove the control panel assembly (see
page 4-12 for the procedure).
Front Mounting Panel
REMOVING THE MAGNETRON
Magnetron
1100 W
Inverter Board
Rear Mounting Panel
5.
Discharge the 1100 Watt inverter as fol-
lows. NOTE: Make sure that the screw-
driver touches ground before touching the
magnetron terminals.
a) Use a plastic handle screwdriver and
touch the metal tip to the case of the
magnetron.
b) Touch the screwdriver shaft against
either of the two magnetron terminals
for approximately 5 seconds.
4-22
Touch The Screwdriver Tip
To The Magnetron Case
Touch The Screwdriver Shaft
To Either Magnetron Terminal