Whirlpool MH9180XL Service Manual page 27

b) Disconnect the 3-wire (red, white, &
black) sensor connector from display
board connector P5.
Humidity Sensor Connector (P5)
c) Remove the two top cover screws from
the rear panel.
Screw
d) Remove the two top cover screws from
the front corners.
Top Cover
Screw
4 Front Top Cover Locking Tabs
Screw
Rear Panel
e) Remove the two screws and ground
wire from the sensor and remove the
sensor from the bracket.
f) Slide the top cover to the left and un-
hook the four front locking tabs in the
cover with the slots in the chassis, (see
the lower left photo).
g) Lift the top cover and pull the sensor
cable through the access hole, and
remove the sensor.
Ground Wire Screw
Humidity Sensor
Screw
Position Humidity Sensor Cable Here
REASSEMBLY NOTE: When you reinstall the
humidity sensor on the bracket, be sure to
position the cable facing down, as shown in the
photo.
Screw
Electrical Shock Hazard
Connect green ground wire to ground
screw.
Failure to do so can result in death or
electrical shock.
4-5
Ground Wire Screw
Access Hole
WARNING