Advertisement
Preparing the Ice Machine for Use
Unpack the machine and place it on a sturdy level surface. The machine
should normally be operated in an ambient temperature of up to 20º C (68ºF).
It is recommended that the packaging materials are retained for future secure
movement or transport.
The refrigerant inside the machine must have time to settle following
transportation and a minimum stabilisation period of three hours is suggested
prior to switching on the machine.
There are two ventilation grilles in the machine cover, one in the lower left
hand side and one in the upper rear. To assure correct machine operation
these grilles must not be obstructed and a gap of at least 10 cm. (4 inches)
between the machine and other appliances or walls must be maintained.
Remove the Water Tank (the lower of the two removable drawers) from the
machine front and pour in fresh tap water to the MAX line of the Water Level
Indicator on the front of the water tank. If desired bottled water may be used in
the machine. Place the Water Tank fully home into its recess.
Remove the Ice Cube Container drawer and replace, again ensuring that it is
fully home in its recess.
Ensure the Cover with Window is closed.
Machine Operation
Plug the machine mains electricity lead in to a suitable supply and switch on
the On/Off Switch situated in the lower right hand side panel. The On/Off
Switch is illuminated and should light up.
The machine may bleep several times whilst the internal components reset
themselves. If this does happen the bleeping should last no longer than 20
seconds. If the bleeping continues for a longer period withdraw both the Water
Tank and the Ice Cube Container slightly and re-insert them ensuring they are
fully home within their recesses. When the Water Tank is withdrawn the
WATERTANK indicator should change from green to red or red/orange, and
when re-inserted the indicator should go green. If the WATERTANK indicator
stays red or red/orange this could mean that the internal water level indicator
is not operating correctly. Remove the Water Tank and ensure that the black
float in the transparent level indicator on the back (internal) side of the tank is
free, ie that the float is not stuck at the bottom of the indicator. If necessary
tap the indicator to free the float.
Page 4 of 8
Advertisement
