Advertisement
The ice cube size S (small) of the SELECT button should be illuminated red
as this is the default setting.
Press and hold down for two seconds the START button on the Function
Display. The machine will start up with the water pump, cooling fan and
compressor starting to operate. Looking through the right hand side of the
window in the cover water will be seen entering the water tray.
Ice cubes will be produced in approximately 12 minutes (on the S selection).
When ice cubes have been deposited in the Ice Cube Container the machine
will bleep four times after which ice cubes may be taken out. Attempts to
remove ice cubes from the Ice Cube Container earlier in the cycle may result
in continuous bleeping depending on when during the cycle removal is
attempted. If the machine does bleep continuously when the Ice Cube
Container is removed then replace the Container.
The machine will continue to produce ice cubes at approximately 12 minute
intervals. Some variation in cube size should be expected on initial switch on
however such variation should be minimised once the machine has settled
down.
When the Ice Cube Container is completely full the machine will automatically
detect this and bleep 10 times and, if the container is not emptied, the
machine will go into sleep mode after approximately 5 minutes. Emptying a
full Ice Cube Container or replacing the Container in its recess will
automatically start the ice making cycle. If the Ice Cube Container is not
emptied the cubes will begin to melt and the water produced will drain into the
Water Tank. When sufficient cubes have melted the ice making cycle will start
again automatically.
If the WATERTANK indicator goes red or red/orange this indicates that the
Water Tank is getting low and requires topping up. The Water Tank must not
be topped up during the last two or three minutes of the ice cube production
cycle as any unfrozen water in the water tray is deposited back into the Water
Tank when the water tray inverts. If the Water Tank is removed and the water
tray inverts water will be deposited in to the base of the machine and on to the
surface on which the machine is standing. The ideal time to top up the Water
Tank is just after the four bleeps mentioned above. Topping up immediately
the indicator turns from green to red or red/orange is not necessary.
When topping up a machine which has been running for a number of cycles
the water level should be topped up to approximately 5mm (¼ inch) below the
MAX line of the Water Level Indicator. This is to allow for the Water Tank to
accept the contents of the water tray after water tray inversion without the
Water Tank overflowing.
The machine can be stopped at any time by pressing the STOP button on the
Function Display. If this is done the red START indicator will flash.
Page 5 of 8
Advertisement
