Charmglow 720-0677 User Manual page 34

Figure 246
CSA INTERNATIONAL
Project 2078110
35 of 46
Remove all packages before using this unit.
WARNING
1. Use two or more people to move and install this unit. Failure to do so can result in back or other
injury.
2. To ensure proper ventilation for your refrigerator, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 40˚F (5˚C) and below
105˚F (40˚C). This unit must be installed in an area protected from the elements.
3. The refrigerator must be installed with all electrical connections in accordance with state and
local codes. A standard electrical supply (110V AC only , 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and ordinances is required.
4. Do not kink or pinch the power supply cord of refrigerator.
5. The fuse (or circuit breaker) size should be 15 amperes.
6. It is important for the refrigerator to be level in order to work properly. You may need to
make several adjustments to level it.
7. Never allow children to operate, play with or crawl inside the refrigerator.
8. Do not use solvent-based cleaning agents of abrasives on the interior. These cleaners my
damage or discolor the interior.
9. Do not use this appliance for any purpose other than its intended usage.
INSTALLATION INSTRUCTIONS
Before Using Your Unit
•
•
•
Setting the Temperature Control
•
•
•
•
Electrical Connection
•
•
Remove the exterior and interior packing.
Before connecting the unit to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Your unit has only one control for regulating the temperature in the compartment. The
temperature control is located on the upper side of the compartment.
The first time you turn the unit on, set the temperature control to "5".
The range of the temperature control is from position "OFF" to "5". "1" is the warmest
and "5" is the coolest. After 24 to 48 hours, adjust the temperature control to the setting
that best suites your needs. The setting of "3" should be appropriate for normal use.
To turn the appliance off, turn the temperature control to "OFF".
Turning the temperature control to "OFF" position stops the cooling cycle but does not
shut off the power to the unit.
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the unit will not
start.
34