Connecting Cables To Terminals - Kenwood Z828MP Instruction Manual

Connecting Cables to Terminals

Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
A–7 Red
A–8 Black
Speaker
Connector
B–1 Purple
B–2 Purple/Black
B–3 Gray
B–4 Gray/Black
B–5 White
B–6 White/Black
B–7 Green
B–8 Green/Black
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground)
Connection
Fuse(10A)
+
Rear Right ( )
–
Rear Right ( )
+
Front Right ( )
–
Front Right ( )
Wiring harness
+
(Accessory1)
Front Left ( )
–
Front Left ( )
+
Rear Left ( )
–
Rear Left ( )
Battery cable (Yellow)
Ignition cable (Red)
A–7 Pin (Red)
A–4 Pin (Yellow)
8
Connector A
7
8
Connector B
7
Rear right output/ Non-fading right output (Red)
Rear left output/ Non-fading left output (White)
Front right output (Red)
Front left output (White)
AUX right input (Red)
AUX left input (White)
FM/AM antenna input
To KENWOOD disc changer/ DAB control input
KPA-SD100/KPA-HD100/KPA-SS100
NOTE
To connect these leads, refer to the relevant
instruction manuals.
External amplifier control cable
(Pink / Black)
EXT.
CONT.
TEL mute cable (Brown)
TEL MUTE
Power control/ Motor antenna
control cable (Blue/White)
P.CONT
ANT.
CONT.
6 4 2
NOTE
5 3 1
If no connections are
6 4 2
made, do not let the cable
5 3 1
come out from the tab.
— 50 —
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
Antenna Cord (ISO)
To "EXT.AMP .CONT." terminal of the amplifier
having the external amp control function.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
NOTE
To connect the KENWOOD navigation
system, consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.