Operation; Cleaning And Maintenance - Omnitronic PSM-6.5A User Manual

7. OPERATION

Switch the device on. After switching on the speaker-system, wait 8 to 10 seconds until you turn the volume-
control in order to avoid speaker-damage.
Caution! Increase the level only so far that the CLIP-LED lights up shortly. Thus, you avoid that the output
signal is distorted and your speakers are damaged.
When operating the speaker-system, please make sure that the loudspeakers always sound well. When
distorsions can be heard, either the amplifier or the loudspeaker is overloaded. Overloads can quickly lead to
amplifier or speaker damage.
In order to avoid damage, please reduce the volume immediately when distortions can be heard. When
speaker-systems are destroyed by overload, the guarantee becomes void.
Always check the sound pressure level with a meter in order to keep to the threshold.
If you want to switch off the system, switch off the speaker-system first in order to avoid acoustic shocks
on the speakers.

8. CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the speaker-systems or parts of the speaker-system have to be tighly
connected and must not be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the speaker-system. Please use a soft lint-free and moistened cloth.
Never use alcohol or solvents!
There are no servicable parts inside the speaker-system. Maintenance and service operations are only to be
carried out by authorized dealers.
Positions A, B and C can be used for adjusting the
HF in order to compensate different room
acoustics.
A – dampened room, +2 dB @ 10-20 kHz
B – normal room
C – hall-like room, -2 dB @ 10-20 kHz
Positions D, E and F can be used for adjusting the
bass in order to compensate different installation
possibilities..
D – Center, +2 dB @ 20-80 Hz
E – Wall installation
F – Corner installation, -2 dB @ 20-80 Hz
25/26 11036473_V_1_0.DOC