Components Behind The Control Panel; Latch Cover - Wolf Wall Oven-2 Series Technical & Service Manual

W W a a l l l l O O v v e e n n S S e e r r i i e e s s
W W a a l l l l O O v v e e n n S S e e r r i i e e s s
COMPONENTS BEHIND CONTROL PANEL:
TURN OFF THE ELECTRICAL POWER GOING TO
THE OVEN BEFORE SERVICING.
IN ORDER TO REMOVE THE CONTROL PANEL
AND COMPONENTS BEHIND IT, THE OVEN WILL
HAVE TO BE PULLED OUT APPROXIMATELY 12
INCHES FROM ITS INSTALLATION AND THE
FRONT OVEN TOP PANEL WILL NEED TO BE
REMOVED.
Latch Cover Removal
Extract the two screws that mount the latch cover to the
mounting plate. (See Figure 4-9). Now, lift latch cover
from unit.
Motorized Door Latch Assembly Removal
Begin by opening the oven door. Extract the screws
and remove the face plate. Now, extract the two
screws that secure the latch assembly to the mounting
bracket (located just below the control panel). (See
Figure 4-10). Now, lift the rear of the latch assembly up
from the mounting slots. Then, slide the latch assembly
out so you can unplug the wires from the micro switch-
es and lock motor. (See Figure 4-11).
Thermal Limiter Removal
NOTE: Double Oven lower
To remove the limit switch you need to remove the cen-
ter trim and latch assembly. Extract the two screws that
secure the limit switch. Lift the limit switch out and dis-
connect the wires.
NOTE: Access and removal of limit switch can also be
gained from the rear of the unit by removing the lower
cooling fan assembly. This is the recommended proce-
dure.
Thermo Limiter Removal
NOTE: Single Oven & Double oven upper cavity
The thermo limiter is mounted on the back panel above
the left convection fan. To remove the thermo limit,
remove unit from its installation, Then disconnect the
wiring to the limit and remove. (See Figure 4-12)
NOTE: The thermo limiter can be reset if it trips. If the
thermo limiter has been tripped, you can reset it by
removing the left convection baffle and convection fan
from the oven cavity in a single oven or upper cavity in
a double oven. Reach through the left convection fan
opening. Limiter is located directly above the opening
and to the right. You can now reset the limit.
Component Access & Removal
Figure 4-9. Latch Cover Removal.
Figure 4-10. Motorized Door Latch Removal.
Figure 4-11. Motorized Door Latch Removal.
Figure 4-12. Limit Switch Removal.
4-5