G-Analyzer Display Switching; Graphic; Text; Press The [Next] Button - Kenwood KDC-MP732 Instruction Manual

General features
Display Type E

G-Analyzer display Switching

Alternates G-Analyzer display when the Display
type is set to "Display Type E". (G: gravity)
• Before alternating G-Analyzer display, you are
required to setup <G-Counter Level set> (page 42),
<G-Analyzer Calibration setup> (page 42) and <G-
Analyzer Horsepower Gauge setup> (page 43).
1
Select the key function section

Press the [NEXT] button.

Repeatedly press the button until "DISP" is

displayed above the [2] button.

Refer to <Notes on Multi-function Key System>
(page 9).
2

Enter display control mode

Press the [2] ("DISP") button.

3

Select the display mode

Press the [1] ("MODE") button.

Select the "Display Type E" display.
4
Enter G-Analyzer display select mode
Press the [3] ("GMENU") button.
5
Select the G-Analyzer display

Push the Control knob towards [4] or

[¢].
G-Force Sensor display
Point
22
|
English
G- Graphic display*
G-Meter display

(Graphic)

G-Meter display

(Text)

G-Counter display
Time
• G-Graphic display
Displays the condition of G in horizontal direction
(e.g; when turning the curve) by the graphic.
• * G-Graphic can be switched to customized pictures.
Refer to <Picture downloading> (page 49) and <G-
Graphic Select> (page 44). (KDC-X790 only)
• G-Meter display (Graphic)
Displays the maximum value of acceleration G, right
direction G, and left direction G by the numerical
value.
• G-Meter display (Text)
The maximum value of acceleration G, right direction
G, and left direction G is displayed by the numerical
value. The value of G is only the reference, so is
different from the actual value.
• G-Counter display
Adds the point of the acceleration level. The point is
determined after a lapse of 1 hr drive or at power off
(ACC Off ), and then it will be displayed by the graph.
Furthermore, the G-Counter displays the average
of the past data by the line. (The scale of graph is
determined along with the largest point among the
past 10 data.)
• The value of G-Meter display and G-Counter display
can be reset by <G-Analyzer Reset> (page 42).
6
Exit display control mode
Press the [6] ("RTN") button.