Adjusting The Detail Of Audio Control; Audio Setup - Kenwood KDC-MP732 Instruction Manual

General features
Function of the KDC-X790
Adjusting the detail of Audio
Control
Among the Basic Audio items, you can adjust the
Bass level, Middle level, and Treble level in detail.
1
Select the Basic Audio item
Select the desired item to be set in detail from
followings;
• Bass level
• Middle level
• Treble level
For how to select Basic Audio items, see <Audio
Control> (page 11).
2
Enter Detail adjustment mode of Audio
Control
Press the [VOL] knob for at least 1 second.
3
Select the Detail Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Detail Audio item
Turn the [VOL] knob.
Bass level
Adjustment Item Display
Bass Center Frequency "Bass FRQ"
Bass Q Factor "Bass Q Factor" 1.00/1.25/1.50/2.00
Bass Extend "Bass EXT"
Middle level
Adjustment Item Display
Middle Center Frequency "Middle FRQ" 0.5/1.0/1.5/2.0 kHz
Middle Q Factor "Middle Q
Factor"
Treble level
Adjustment Item Display
Treble Center Frequency "Treble FRQ" 10.0/12.5/15.0/17.5 kHz
5
Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
12
|
English

Audio Setup

Setting the Sound system, such as Cross over
Network.
1
2
3
4
Range
40/50/60/70/80/100/
120/150 Hz
OFF/ON
Range
1.00/2.00
Range
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL], [ANG] and [ATT]
buttons.
Select the source to adjust
Press the [SRC] button.
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display
Front High Pass Filter* 2 "HPF-F Fc"
2
Rear High Pass Filter* "HPF-R Fc"
1,2
Low Pass Filter* "LPF-SW"
Subwoofer Phase* 1,2,3 "SW Phase"
Volume offset "Vol-Offset"
Loudness "LOUD"
Dual Zone System "2 ZONE"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
1
• * You can control this item when <Subwoofer
Output> (page 13) is set to "SW ON".
2
• * You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "OFF".
• * 3 You can control this item when Low Pass Filter is not
set to Through.
Range
Through/40/60/80/100/120/
150/180/220 Hz
Through/40/60/80/100/120/
150/180/220 Hz
50/60/80/100/120/
Through Hz
Reverse (180°)/ Normal (0°)
–8 — ±0
OFF/ON
OFF/ON