Dsi (Disabled System Indicator); Dual Zone System Setting; Bass Management System); B.m.s. Frequency Offset - Kenwood DPX-MP4100 Instruction Manual

In Standby mode

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the ACC is
set to OFF, warning potential thieves.
Display Setting
"S.I ON" LED flashes.
"S.I OFF" LED OFF.
Other than Standby mode/
When the Dual Zone System is ON

Dual Zone System Setting

Setting the Front channel and Rear channel sound
in the Dual Zone System.
Display Setting
"ZONE2 R" Sub source (Auxiliary input source) is to be rear
channel.
"ZONE2 F" Sub source (Auxiliary input source) is to be front
channel.
Other than Standby mode
B.M.S. (Bass Management System)
Adjust the bass boost level of the external amplifier
using the main unit.
Display Setting
"BMS FLT" Bass boost level is flat.
"BMS +6" Bass boost level is low (+6dB).
"BMS +12" Bass boost level is mid (+12dB).
"BMS +18" Bass boost level is high (+18dB).
⁄
• Refer to the catalog or instruction manual for power
amplifiers that can be controlled from this unit.
• For amplifiers, there are the models you can set from Flat
to +18 dB, and the models you can set from Flat to +12
dB.
When an amplifier that can only be set to +12 is
connected to the unit, "BMS +18" will not work correctly
even if it is selected.
Other than Standby mode

B.M.S. Frequency Offset

Setting the central frequency, boosted by B.M.S.
Display Setting
"BMSF NML" Boost with the normal central frequency.
"BMSF Low" Drop the normal central frequency 20%.
In FM reception

CRSC (Clean Reception System Circuit)

Temporarily have reception alternate from stereo to
mono to reduce multi-path noise when listening to
the FM station.
Display
"CRSC On"
"CRSC Off"
⁄
• Strong electrical fields (such as from power lines) may
cause unstable sound quality when CRSC is turned ON.
In such a situation, turn it OFF.
Setting
The CRSC is ON.
The CRSC is OFF.
|
English
23