Panasonic CF-T5 series Operating Instructions Manual page 27

Starting Up and Standby and Hibernation Mode
The computer will not auto-
matically enter standby/
hibernation.
When logging on (e.g.,
resuming the computer),
audio is distorted.
Cannot resume.
Other startup problems.
Shutting Down
Windows does not shut
down.
Password
Even after entering the
password, [Type your pass-
word] is displayed again
Display
No display.
The screen is disordered.
The external display does
not work normally.
"Phoenix Always Launcher"
was used to change the res-
olution setting, but that set-
ting is not applicable.
Battery
The battery indicator is
lights red
If you connect to a network using wireless LAN function, perform access point settings.
( Reference Manual "Wireless LAN")
If you do not use wireless LAN function, turn off wireless LAN function. (
ence Manual "Wireless LAN")
Make sure that you are not using any software that regularly accesses the hard disk.
Perform the following steps to change the audio settings to prevent audio output.
A Click [start] - [Control Panel] - [Sounds, Speech, and Audio Devices] - [Sounds and
Audio Devices], and click [Sounds].
B Set [Windows Logon] and [Windows Logoff] to [(None)].
One of the following operations may have been carried out.
• In standby mode, the AC adaptor or battery pack was disconnected, or a peripheral
was connected or disconnected.
• The power switch was slid for four seconds or longer to forcibly turn off the computer.
Slide the power switch to turn on the computer. Data not saved will be lost.
Check to see if there was a disk error.
A Remove all peripheral devices including an external display.
B Click [start] - [My Computer] and right-click [Local Disk(C:)], and click [Properties].
C Click [Tools] - [Check Now].
D Select the option in [Check disk options] and click [Start].
Start the computer in Safe Mode and check the error details. (
does not start up")
Remove all peripheral devices.
Wait one or two minutes. It is not a malfunction.
NumLk to disable the ten-key mode, and then input.
If lights up, press
Caps Lock to disable the Caps Lock mode, and then input.
If lights up, press
The external display is selected. Press
play has been switched completely before pressing
When using an external display,
• Check the cable connection.
• Turn on the display.
• Check the settings of external display.
The display is turned off by the power-saving function. To resume, do not press the direct
selection keys, but press any other key like
The computer entered standby or hibernation by the power-saving function. To resume,
slide the power switch.
The screen may become darker. Press
Changing the number of display colors and resolution may affect the screen. Restart the computer.
Connecting/disconnecting an external display may affect the screen. Restart the computer.
If the external display does not support the power saving function, it may not work nor-
mally when the computer enters the power saving mode. Turn off the external display.
You cannot set the resolution setting to a value of resolution this computer does not sup-
port.
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the indicator light is orange. If
you do not have an AC adaptor, save your data and power off your computer. After
replacing the battery pack with a fully charged one, turn your computer on again.
page 26 "
Fn + F3 to switch the display. Wait until the dis-
Fn + F3 again.
Ctrl .
Fn + F2 to make the screen brighter.
Refer-
Windows
27