Panasonic CF-T5 series Operating Instructions Manual page 29

Others
No response.
Unable to input password
Error Code/Message
Follow the instructions below when an error code or message appears. If the problem persists or if the error code/mes-
sage displayed is not shown here, contact your technical support office.
Error Code/Message
0211 Keyboard error
0251 System CMOS
checksum bad -
Default configuration
used
0271 Check date and
time settings
0280 Previous boot
incomplete - Default
configuration used
Press <F2> to Setup
Operating System not
found
To start the Setup Utility
A Restart the computer.
B Press F2 while [Panasonic] boot screen is displayed.
Ctrl + Shift + Esc to open Task Manager and close the software application that
Press
is not responding.
An input screen (e.g., password input screen at startup) may be hidden behind another
Alt + Tab to check.
window. Press
Slide the switch for four seconds or longer to shut down the computer, and then slide the
power switch to turn it on. If the application program does not work normally, uninstall
and reinstall the program. To uninstall, click [start] - [Control Panel] - [Add or Remove
Programs].
Some keyboards have unusable keys (e.g. the "
Use the other key when you press the key and the alarm sounds.
Disconnect external keyboard.
An error has occurred in the memory of Setup Utility settings. This occurs when the memory con-
tent is changed by an unexpected program operation, etc.
Start the Setup Utility and return the settings to the default values, and then change the set-
tings as necessary.
If the problem persists, the internal clock battery may need to be replaced. Contact your tech-
nical support office.
The date and time settings are not correct.
Start the Setup Utility and set the correct date and time.
If the problem persists, the internal clock battery may need to be replaced. Contact your tech-
nical support office.
Startup has failed repeatedly, so the Setup Utility settings have been returned to the default val-
ues to startup the computer.
Start the Setup Utility and return the settings to the default values, and then change the set-
tings as necessary.
Write down the error details and press
necessary.
The operating system is not installed in the floppy disk or the hard disk that you are going to boot
from.
If using a floppy disk, change the disk to the one you can use for boot.
If using the hard disk, check if the hard disk is recognized in [Information] menu of the Setup
Utility. If the hard disk is recognized, perform the reinstallation (
your technical support office.
If a device is connected to the USB port, disconnect the device, or set [Legacy USB Support]
to [Disable] in the [Advanced] menu of the Setup Utility.
M " key on French keyboards).
Solution
F2 to start the Setup Utility. Change the settings if
page 24). If not, contact
29