Epson Discproducer PP-100N Administrator's Manual page 76

Error Message
Internal
autoloader error
Invalid
state error
No disc
ST1, ST2
No ink cartridge
(C,LC,LM,M,Y,K)
No stacker
ST1, ST2, ST3
Non-standard ink
Continue?
76
Remedy
Perform the procedure below.
1. Turn off the power.
2. Open the disc cover, and check if any dust or foreign
objects are inside.
3. Turn on the power.
If the same error message still appears, repair is required.
Please contact Customer Support.
Turn off the power, and then turn it on again. If the same error
message still appears, repair is required. Please contact
Customer Support.
Load discs into the input stacker (Stacker 1 or Stacker 2).
(See "Disc Loading" in the PP-100N User's Guide.)
The ink cartridge of the displayed color is not installed, or is
not installed correctly.
Correctly install the cartridge of the displayed color. (See
"Changing the Ink Cartridge" in the PP-100N User's Guide.)
Load the displayed stacker, and close the disc cover. (See
"Installing the stackers" on page 24 in this guide.)
To use the ink cartridge, press the
change to a Epson brand ink cartridge, press the CANCEL
button (No), and change the ink cartridge.
Use of non-Epson brand ink cartridges is not recommended.
• Use of non-Epson brand ink cartridges can result in
problems that will not be covered by the warranty.
• Epson cannot guarantee the quality and reliability of non-
Epson brand products. Repairs for any damage or
breakdown of this product due to the use of non-Epson
brand products will not be free of charge even if the
warranty period is still valid.
• This product performs color adjustment based on use of
Epson brand ink cartridges. Use of non-Epson brand ink
products can adversely affect the printing quality and
prevent the product from realizing its maximum
performance.
See "Changing the Ink Cartridge" in the PP-100N User's
Guide for the ink cartridge changing procedure.
Notification
button (Yes). To
Sound