Argox AS-9500 User Manual page 31

Number of Beeps
The number of beeps of a good read can be programmed from 1 -
9. The same number of beeps will be applied to the beeper and
LED in response to a good read. For example, if you program this
option to have five beeps, there will be five beeps and five LED
flashes in response to a good read. The beeps and LED flashes are
in sync with one another. To change the number of beeps, scan the
bar code below and then scan a digit (1-9) bar code and the Save
bar code.
Beep Polarity
Beep Polarity sets the idle and active states of the beeper signal.
When set to Active High, the beeper sounds when the signal shifts
from low to high. When set to Active Low, the beeper sounds
when the signal shifts from high to low.
If the beeper is enabled for a good read , the polarity change takes
effect after the next successful decode or a power cycle. If the
beeper is disabled, a polarity change only takes effect after a
power cycle.
Note: Beep Polarity sets the beeper signal voltage level to either
high (Active Low) or low (Active High). This will affect
Beeper-Good Read settings. If the beeper has been disabled, make
sure it is not turned on accidentally by a polarity change.
Good Read Delay
This sets the minimum amount of time before the imager can read
another bar code. Default = No Delay.
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan
the bar code below, then set the delay (from 0-30,000 milliseconds)
by scanning digits from the inside back cover, then scanning Save.
30