Foscam FI8908 User Manual page 9

WWW.FOSCAM.COM FI8908/FI8908W User Manual
NOTE: If you could not find the camera's IP on the IP camera tool.
Please check if DHCP is enabled in your router, or disable MAC address filter.
Make sure that firewall doesn't block the camera.
Six Options
Choose the IP Camera list and Click right mouse button; there are six options, Basic Properties,
Network Configuration, Upgrade Firmware, Refresh Camera List, Flush Arp Buffer and About IP
Camera Tool as shown Figure 2.2.
Figure 2.2
Basic Properties
There are some devices' information in the Basic Properties, such as Device ID, System
Firmware Version, and Web UI Version. (Figure 2.3)
If there are several cameras on the list, you can choose basic properties to check the device ID
and recognize the IP address belong to which camera you set up, such as Device ID is
00606E8C5058, you can find the same MAC ID sticker at the bottom/back of the camera.
Each camera has its only MAC ID. Sometimes, if you couldn't find the camera's IP on the IP
Camera Tool. May be the firewall block it, you can add this MAC ID to your router and give it a
fixed IP or add the MAC ID as a trusted site. There are two MAC addresses, one is Wired MAC
and the other is WIFI MAC.
7
ShenZhen Foscam Intelligent Technology Co., Ltd
Tel: 86 755 2674 5668 Fax: 86 755 2674 5168