Freestanding Installation; Stove Components; Preparation - Appalachian Stove & Fabricators 36-BW Installation And Operation Procedures

IV . FREESTANDING INSTALLATION

1. STOVE COMPONENTS

The following components are
included with the 36-BW
freestanding model:
A) Model 36-BW stove
B) Ash Pan
C) Firebrick Firebox Liner
D) Assembly Screws
E) Blower Assembly
F) Control Panel Assembly
G) Pedestal (Not Shown)
FIGURE 7
FREESTANDING STOVE COMPONENTS

2. PREPARATION

Proper preparation and planning of the installation will simplify the
process and help achieve effective operation of the unit.
A) Select the location for the stove installation. The stove should be
positioned so that the air flows to the rest of the home in the most direct
route possible.
B) Locate the approximate penetration point of the chimney structure.
Avoid roof areas such as valleys, ridges, dormers and hips.
Place the floor protector in position, if the installation is being made on a
combustible floor. (Section II)
Place the stove in position and check clearances. (Section II)
7