List Function In P.c.t. Mode; New Packet Cluster Data - Kenwood RC-2000 Instruction Manual

LIST FUNCTION IN P.C.T. MODE

To access your desired DX information from the P.C.T
memory in the P.C.T. mode:
1 Press [LIST] (L2).
2 Press [c]/ [d] or turn the MULTI/ CH control to
select the report.
• "s" indicates which DX report is currently
selected.
3 Press [SET] to tune the main transceiver to the
reported frequency.
• Press [DEL] to erase the selected DX information
from the P.C.T. memory. Press [EXIT] to return to
normal P.C.T. information display.
• Press [OK] to view all the comments of the
selected DX station.
38

NEW PACKET CLUSTER DATA

The transceiver can be set to output a beep instead of a
Morse code when new DX Packet Cluster data is
received. Press [MENU] while in group A–3, then turn
the MULTI/ CH control to select Menu No. 49. Press
[SUB], then turn the MULTI/ CH control to access Menu
No. 49B. Select "OFF". "VOICE" can also be set when
you install the optional VS-3 {TS-2000 page 91}.
Note:
You cannot send DX information to a node using the P.C.T. mode.
The DX Packet Cluster data in memory is retained when the
transceiver is turned OFF. However, the sub-receiver's frequency
display returns to the receiving frequency of the DX Packet Cluster
node.