Using Visual Scan - Kenwood RC-2000 Instruction Manual

USING VISUAL SCAN

1 Select your desired frequency using the Tuning
control.
2 Turn the Tuning control or press Mic [UP]/ [DWN]
to select the operating frequency.
• This frequency will be used as the center frequency
for the Visual Scan.
3 Press [F1] (1 s) until you select group B.
4 Press [F1] until you select B–3.
5 Press [VISUAL] to start the Visual Scan.
• To pause the Scan, press [PAUSE]. "P" appears on
the display. Press [PAUSE] again to resume
scanning.
6 To change the center frequency, turn the Tuning
control or press Mic [UP]/ [DWN].
• The displayed frequency changes and the cursor
moves.
• Press [SET] to use the changed operating frequency
as the center frequency.
• Press [RESET] to restore the original center
frequency.
7 To quit Visual Scan, press [EXIT].
40
Note:
You can press the Tuning control to change the Tuning control
and MULTI/ CH control to adjust the operating frequency. "TUN"
or "MLTI" appears to indicate which control mode is selected.
If you start Visual Scan in Memory Recall mode, the memory
channel frequencies will be scanned.
Visual Scan stops while transmitting.
During the Visual Scan, the scanning frequency cannot be
monitored through the speaker.
Depending on conditions, Visual Scan and the conventional
S-meter may indicate different signal strength levels.