Installing The Handstrap - PSC Falcon 4220 Product Reference Manual

Installing the Handstrap

To use the PDA for extended periods of time, install the handstrap for
increased comfort and usability. To install the handstrap, you must have the
standard CF cover installed.
Because the handstrap plate will cover the opening, the handstrap cannot be used
with the open CF (compact flash card) cover.
Complete the following steps:
Figure C-4. Installing the Handstrap
b
A
The procedure for installing the Strap Plate and the Strap is complete.
Product Reference Guide
1. Turn the PDA face-down on a clean, dry surface. Ensure that power is
OFF.
2. Use a small Phillips head screwdriver to remove the two screws securing
the CF cover to the PDA. Align the strap plate with the CF cover. (Refer
to .)
Figure C-4A
CF Cover
3. Reinstall the screws to secure the both the CF Cover and the strap plate
into place.
4. Pull the plastic tab down as shown in
the strap recess at the bottom of the unit.
Strap and
Strap Plate
to insert the strap into
Figure C-4B
Installing the Handstrap
a
B
C-5