Page 2
By Dogtra Remote Controlled Dog Training Collars Owner's Manual Please read this manual thoroughly before operating the Dogtra EDGE RT training collar.
Page 3
Dogtra e-collars are intended for the sole purpose of behavior If the dog is to wear the e-collar for long periods, occasionally or use on other animals. Dogtra Company does not assume any moved to a different location on the dog’s neck. Make sure you liability for the improper use of a Dogtra e-collar.
9. How to change the length of the contact points .... Code setting ............. car outlet. 11. How to attach the belt clip on the EDGE RT ..... European charger 12. How to use the test light........General Training Tips ..........
Main Features of the EDGE RT Overview Intensity selection dial stimulation level (1-8) Antenna 1-Mile range Intensity Selection Dial Dog Selector Dog Selector Dial Dial Medium Constant User expandable to a three-dog system Stimulation Pager High Button Constant (Gray) Stimulation...
Understanding your training system 1. How to turn the EDGE RT on/off Collar strap two red dots together for a moment until the LED light on the LED light will blink every 4 seconds. Contact points holding the two red dots together momentarily. The LED light collar is now shut off.
Page 7
2. The Stimulation/Combination buttons * Holding down the constant stimulation buttons will activate for a maximum of The handheld transmitter uses 4 buttons to send stimulation. 12 seconds. After 12 seconds of constant The LED indicator will blink on both the handheld transmitter stimulation, the stimulation will reset.
3. How to use the dog selector dial 5. How to find the right stimulation The EDGE RT is expandable to use as a 3-dog system. selector dial on top of the handheld transmitter. - DOG 1: Set the dial to 1...
If the unit is used while the LED indicator is red, it will shut down automatically. Using the EDGE RT as a 2 or 3 Dog System additional splitter cables as shown above. Connect 2 splitter cables together to charge all parts of a 2-dog system, or connect 3 splitter cables together to charge all parts of 8.
9. How to change the length of the contact points 10. Code setting To set the coding for the Dogtra EDGE RT transmitter to an with dogs with longer coats. the steps below. 1. Set the stimulation dial to level steps below.
4 Do not touch the contact points of the receiver/collar while code setting the EDGE RT. If you do so, you may receive an electric stimulation. Also, do not attempt to code set the device while the receiver/collar is in contact with dogs, other animals, or people.
Getting started with your EDGE RT Your dog must know some very basic obedience commands before beginning training with the EDGE RT. A dog learns by commands, the trainer can introduce distractions and different locations to strengthen them. Throw in the correct amount of positive and negative reinforcement and you should end up with a well-mannered dog.
Storage maintenance Always start with low levels of stimulation and work your way The EDGE RT should be fully charged before storing for up depending on the disposition of your dog and any given extended periods. While in storage, the unit should be given situation.
To place an order for longer contact points, please - Any electrical conductors will affect the range, such as cars, contact Dogtra or a Dogtra dealer. If you are already using chain-link dog runs, metal buildings, and radio towers. For the longer contact points, you may need to trim the hair on the best results, operate away from these structures.
Dogtra is not responsible for units damaged or lost in transition to Dogtra. Dogtra is not responsible for loss of training time or inconvenience while the unit is in for work under warranty. To register your Dogtra product, log onto our website at www.
Need help?
Do you have a question about the Edge RT and is the answer not in the manual?
Questions and answers