CONTENTS MAIN FEATURES PRODUCT SAFETY AND HEALTH STATEMENTS PACKAGE CONTENTS DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF COLLAR / RECEIVER PARTS BATTERY CHARGER TESTING YOUR COLLAR FITTING THE COLLAR ON THE DOG CHARGING THE BATTERIES ACCESSORIES BASIC MAINTENANCE TROUBLE SHOOTING GUIDE WARRANTY AND REPAIR INFORMATION...
They are not levels. intended for human use or use on other animals. Dogtra Company does not assume any liability for The Dogtra Element 300M Series has a 1/2-mile improper use of the e-collar. range.
PACKAGE CONTENTS DESCRIPTION OF TRANSMITTER PARTS COLLAR DESCRIPTION OF PACKAGE CONTENTS TRANSMITTER PARTS transmitter (1-dog unit) Transmitter Receiver (two collar/receivers for two-dog models) Antenna Battery charger and splitter cable Rheostat Intensity Dial Owner’s manual Indicator Light (LED Window) “Nick” Button Pager Button “Constant”...
Page 5
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS transmitter (2-dog unit) Antenna Transmitter Antenna Nick/Constant Rheostat Toggle Switch Intensity Dial A short 2 antenna is supplied with the transmitter. Indicator Light (LED Window) The antenna must be fastened to the transmitter before using the unit.
Page 6
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS Rheostat Intensity Dial Transmitter Indicator Light (LED Window) The transmitter indicator light (LED) is The Rheostat Intensity Dial is located on the located near the Rheostat Intensity Dial. The top of the transmitter: (0) being the lowest level LED light will come on when a button is pressed.
BUTTON FUNCTIONS DESCRIPTION OF TRANSMITTER PARTS BUTTON FUNCTIONS (1-dog unit) Nick Button Pager Button Constant Button Transmitter Battery Charging Receptacle & Rubber Plug Located on the backside of the transmitter, The transmitter for the the charging receptacle is covered by a rubber single dog unit has three buttons (one on the plug.
Page 8
BUTTON FUNCTIONS BUTTON FUNCTIONS (2-dog unit) “Constant” Button The “Constant” button is located on the bottom left. Pressing the “Constant” button gives Nick/ Constant Toggle Switch continuous stimulation as long as the button is -dog Nick & Constant pushed, for up to 12 seconds. If the button is not -dog (Gray Button) Pager...
BUTTON FUNCTIONS BUTTON FUNCTIONS DESCRIPTION OF When either the orange or gray stimulation button is pressed and the toggle is set on “Nick”, COLLAR / RECEIVER PARTS the receiver emits a single rapid pulse of electrical stimulation. When you press either the orange or gray Collar strap stimulation button and the toggle is set on “Constant”, the receiver emits a continuous...
Page 10
DESCRIPTION OF COLLAR / RECEIVER PARTS DESCRIPTION OF COLLAR / RECEIVER PARTS Receiver Indicator Light (LED) Receiver On/Off Magnetic Switch (Red Dot) Located on the front of the receiver/collar, To activate the receiver/collar, place the red the indicator light comes on and blinks once dot on the back of the transmitter to the red dot every 2 seconds after the collar has been turned on the collar/receiver.
(splitter) cables as shown. This enables you to Internal Antenna charge the transmitter and both receivers at the same time. All Dogtra E-collars have non-exposed antennas that are located inside the collar/ receiver.
TESTING TESTING TESTING YOUR 2. The indicator light(LED) on the collar/receiver COLLARS will light briefly when the nick button is pressed. Pressing the Constant button will light the indicator for as long as you hold the button down, up to twelve seconds. 3.
If the collar is too loose, electrical contact will be inconsistent and your corrections will be inconsistent also. Dogtra uses surgical stainless steel contact points and Anti-microbial plastic to protect the dog’s skin. ATTENTION!
CHARGING THE BATTERIES CHARGING THE BATTERIES The indicator light on the transmitter or CHARGING THE BATTERIES receiver will not ACTIVATE. The transmitter or receiver does not stay on when one of the stimulation or pager buttons is pushed. Battery Charging Procedure 1.
(888) 811-9111. You may also browse the selection at www.dogtra.com. Hold the transmitter away from your body and avoid touching the antenna, to get the greatest range.
If you suspect your unit is malfunctioning please refer to the “Troubleshooting Guide” so pay attention.) before you send your unit in for service. If you have any questions or concerns, you may direct your inquiries to info@dogtra.com or call (888) 811-9111.
Page 17
- The antenna(s) may be damaged. To order - For Dogtra units over two years old from the parts, please contact Customer Service at purchase date, the batteries may need to be (888) 811-9111.
Labor fees will be purchase is not available at the time of service, variable depending on the extent of work Dogtra will estimate the age of the unit by the required. The Limited Lifetime Warranty will serial number. Serial number estimates can be expire 5 years from the date a model is different than the actual purchase time.
Page 19
202NCP, 1400NCP, 1402NCP, 1500NCP and shipping service will be at the customer’s 1502NCP will also not be covered. All expense. Dogtra is not responsible for loss of replacement cost for either the transmitter or training time or inconvenience while the unit is in receiver will be the owner’s responsibility.
Page 20
Or, you can visit our website at www.dogtra.com. Click on the Service Request Form, print it out and follow the instructions. If repair costs are not covered under warranty, we will call you for credit card information once the work has been completed.
Need help?
Do you have a question about the Element 300M series and is the answer not in the manual?
Questions and answers