Table of Contents
Advertisement
MAINTENAN( :E
11
Depending on your model, your RV range or cooktop will
Do not place excessive weight on an open oven door or
featurethreeorfoursurfaceburners. Eachburnerissecured
stand on an open oven door as, in some cases, it could
in place with a screw. When burner is cool, remove the screw
cause the range to tip over, breakthe door, or cause senous
before removing the burner. When re-installing the surface
injury to the user.
burner be sure to replace the screw.
When opening the oven door, allow steam and hot air to
Ifthesufface burnerdoesnotlight, checktoseeiftheburner
escape before reaching in oven to check, add or remove
ports are clogged. If so, clean with a straight pin or small
food.
metal paper clip. Be sure the standing pilot is lit. Check to be
sure that the burner is correctly installed.
Toinstall surface burner: The air shutterend onthe burner
YourRV rangefeaturesone oven rackwitha choiceoftwoor
shouldfitoverthe orificehood.
three rackpositions. The ovenrackisdesignedwitha safety
lock-stoppositionto keep the rackfrom accidentlycoming
_tt
completely out ofthe oven when pullingthe rackout toadd or
remove food. The rack also features two tabs to keep the
\_\.
rack from rattling during travel.
"\\
er
To install surface burner with Piezo ignition: The two
tabson eachflashtubeshouldbe securelyinsertedintothe
two slotson each burnerhead,
Slo_
_
I CAUTION: DOnot attempt to change the rack position
..... _"_i __'_
t when the oven is hot.
)
_, ,,
Two
To remove: Be sure rack is cool. Pull the rack straight out
Tabs
until it stops. This releases the two tabs on the sides of the
rack. Tilt the front end of the rack up, then push the rack to
the back of the oven. Liftthe rear of the rack up, then remove
it from the oven.
The flashtube "hold down" clips should secure the flashtube
in place. The clips are located under the metal shield.
To replace: Place the oven rack in the oven, on _
of the
racksupports. P ushthe racktothe backofthe ovento allow
Flash
_Flash..._
the rackto drop intoplace. Pull the rackforward to the stop
e_
_.u_b
position.Then, as you push the rack back, lowerthetwo tabs
(_
under the rack support. Th!s will anchorthe rack intoplace
_"Hold
down"
and prevent it from rattling during travel.
Hold down"
Hide quick links:
Advertisement
Table of Contents
