Operation Warnings; Error Messages; Warning Messages - Sony PXW-FS7 Operating Instructions Manual

Operation Warnings

If a warning, caution, or operating condition that requires confirmation occurs on the camcorder, a
message is displayed in the viewfinder, the recording indicators start flashing, and a warning sound is
emitted.
The warning sound is emitted from the built-in speaker and headphones connected to the headphone
connector.

Error Messages

The camcorder will stop operation when the following kind of display occurs.
Viewfinder Warning
message sound
E + error code Continuous

Warning Messages

Follow the instructions provided if the following display occurs.
Viewfinder Warning
message sound
Media Near Full Intermittent Flashing
Media Full Continuous
Battery Near End Intermittent Flashing
Battery End Continuous
Temperature High Intermittent Flashing
Voltage Low Intermittent Flashing
Insufficient Voltage Continuous
Recording Cause and Solution
indicator
High-speed Indicates an abnormality in the camcorder. Recording stops,
flashing even if zREC is displayed in the viewfinder.
Turn off the camcorder, and check for any problem with
connected devices, cables, or media. If the error persists when
the camcorder is turned on again, contact your Sony service
representative.
(If the camcorder does not turn off when the POWER switch
is set to OFF, remove the battery or disconnect the DC IN
supply.)
Recording Cause and Solution
indicator
The remaining capacity on the XQD memory card is getting
low.
Replace at the earliest convenience.
High-speed Clips could not be recorded, copied, or split because there is
flashing no remaining capacity on the XQD memory card.
Replace immediately.
The remaining capacity of the battery pack is getting low.
Recharge at the earliest convenience.
High-speed The battery pack is empty. Recording is disabled.
flashing Stop operation and replace the battery pack.
The internal temperature is high.
Turn off the camcorder and allow it to cool down before
operating it again.
The DC IN voltage is low (level 1). Check the power source.
High-speed The DC IN voltage is too low (level 2). Recording is disabled.
flashing Connect a different power source.
105