How To Set Up Central Control Address Number - Toshiba RAV-SM562MUT-E Service Manual

7. External View of P.C. Board
8. Address Setup
In addition to set up the central control address, it is necessary to change the indoor unit number.
(Line/Indoor/Group address).
For details, refer to TCC-LINK Adapter Installation Manual.

11-3. How to Set up Central Control Address Number

When connecting the indoor unit to the central control remote controller using TCC-LINK adapter, it is neces-
sary to set up the central control address number.
• The central control address number is displayed as the line No. of the central control remote controller.
1. Setup from remote controller at indoor unit side
* If you use the network adapter P .C. board, it is effective only when No. 7 of setup switch SW01 on P .C.
board is turned off.
<Procedure> Perform setup while the unit stops.
1
VENT
TEST
Push + buttons for 4 seconds or more.
When group control is executed, first the unit No.
control are selected. In this time, fans of all the selected indoor units are turned on. (Fig. 1)
RLL
(Keep displayed status without pushing
In case of individual remote controller which is not group-controlled, Line address and Indoor unit address
are displayed.
2
Using temperature setup
3
Using timer time
table (Table 1).
4
SET
Push button. (OK if display goes on.)
• To change the item to be set up, return to Procedure
5
TEST
Push button.
The status returns to usual stop status.
(Table 1)
Setup data Central control address No.
0001
0002
0003
:
0064
0099 Unset (Setup at shipment from factory)
TEMP.
buttons, specify item code
TIME buttons, select the setup data. The setup data is shown in the right
1
2
3
:
64
Terminator (SW01)
85
RLL
is displayed and all the indoor units in the group
UNIT
button.)
2
.
2
1
5
– 71 –
52
03
.
(Fig.1)
SET DATA
UNIT No.
R.C. No.
TEMP.
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
FILTER
RESET TEST SET CL UNIT
3
1
4