Adjusting Valve Clearance; Cooling System - Generac Power Systems 04673-2 Installation And Owner's Manual

following procedures are to be followed:
• DO NOT SMOKE when near the battery;
• DO NOT cause flame or spark in battery area; and
• Discharge static electricity from body before touch-
ing the battery by first touching a grounded metal
surface.
Be sure the AUTO/OFF/MANUAL switch is set to
the OFF position before connecting the battery
cables. If the switch is set to AUTO or MANUAL,
the generator can crank and start as soon as the
battery cables are connected.
Be sure the utility power supply is turned off, and
the 5A fuse is removed from the generator control
panel, or sparking may occur at the battery posts
as the cables are attached, causing an explosion.
4.8

ADJUSTING VALVE CLEARANCE

After the first six months of operation, adjust the
valve clearance in the engine.
Important: If feeling uncomfortable about doing this
procedure or the proper tools are not available, contact
the nearest Authorized Dealer for service assistance.
This is a very important step to insure longest life for
the engine.
To adjust valve clearance:
• Make sure the engine is at room temperature.
• Make sure that the spark plug wire is removed from
the spark plug and out of the way.
• Remove the four screws attaching the valve cover with
a #2 or #3 phillips screwdriver.
• Make sure the piston is at Top Dead Center (TDC) of
its compression stroke (both valves closed). To get
the piston at TDC, remove the intake screen at the
front of the engine to gain access to the flywheel nut.
Use a large socket and socket wrench to rotate the
nut and hence the engine. While watching the piston
through the spark plug hole. The piston should move
up and down. The piston is at TDC when it is up as
high as it can go.
• Loosen the rocker jam nut.
wrench to turn the pivot ball stud while checking
clearance between the rocker arm and the valve stem
with a feeler gauge. Correct clearance is 0.002-0.004
inch (0.05-0.1 mm).
Hold the rocker arm jam nut in place as the pivot
ball stud is turned.
When valve clearance is correct, hold the pivot ball stud
in place with the allen wrench and tighten the rocker
arm jam nut. Tighten the jam nut to 174 in/lbs. torque.
After tightening the jam nut, recheck valve clearance to
make sure it did not change.
20
Section 4 — Maintenance
Air-cooled 7 kW, 12 kW and 15 kW Generators
Use an 10mm allen
NOTE:
Figure 4.10 - Valve Clearance Adjustment
Pivot Ball
Stud
Jam Nut
• Install new valve cover gasket.
• Re-attach the valve cover.
Start all four screws before tightening or it will not
be possible to get all the screws in place. Make sure
the valve cover gasket is in place.
• Re-attach the spark plug wire to the spark plug.
• Repeat the process for the other cylinder.
4.9

COOLING SYSTEM

Air inlet and outlet openings in the generator compart-
ment must be open and unobstructed for continued
proper operation. This includes such obstructions as
high grass, weeds, brush, leaves and snow.
Without sufficient cooling and ventilating air flow, the
engine/generator quickly overheats, which causes it to
quickly shut down. (See Figure 4.9 for vent locations.)
Figure 4.9 – Cooling Vent Locations
Rocker
Arm
Valve
Stem
NOTE: