Lester 18710 T Operating Instructions Manual

LESTRONIC II 48 VOLT AUTOMATIC
MODEL 18710
AC Input:
DC Output:
Battery Specifications:
PLEASE SAVE THESE IMPORTANT SAFETY AND OPERATING INSTRUCTIONS
For correct operation of the equipment, it is important to read and be familiar
with this entire manual before installing and operating the charger.
LOOK FOR THIS SYMBOL TO POINT OUT SAFETY PRECAUTIONS. IT MEANS:
BECOME ALERT—YOUR SAFETY IS INVOLVED. IF YOU DO NOT FOLLOW THESE
SAFETY INSTRUCTIONS, INJURY OR PROPERTY DAMAGE CAN OCCUR.

IMPORTANT SAFETY INSTRUCTIONS

This manual contains important safety and operating
instructions. Before using battery charger, read all
instructions and cautionary markings on battery
charger, battery, and product using battery.
• Do not expose charger to rain or snow.
• Use of an attachment not recommended or sold by
the battery charger manufacturer may result in a
risk of fire, electric shock, or injury to persons.
• To reduce risk to damage to electrical plug and
cord, pull by plug
disconnecting charger.
• Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
• When using an extension cord, make sure that:
www.lesterelectrical.com

BATTERY CHARGER

Specifications
120 volts, 15 amps, 60 Hertz, single-phase
48 Volts, 25 Amps, Tapering to 8 Amps
For use with 48-volt, 24-cell, series connected, 180-350 amp-hour, liquid electrolyte
(wet) lead-acid batteries
DO NOT DISCARD THIS MANUAL AFTER READING.
rather than cord when
TYPE 48LC25-8ET
° Pins on plug of extension cord are t h e same
number, size, and shape as those of plug on
charger;
° Extension cord is properly wired and in good
electrical condition;
° Wire size is large enough for AC ampere rating
of charger.
• Do not operate charge with damaged cord or plug;
replace it immediately.
• Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way. Take it to a qualified service center.
• Do not disassemble charger; take it to a qualified
service center when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
1
*01610*
01610K