Table of Contents
Advertisement
SETUP WIZARD
The Setup Wizard allows you to customize your GKPX-14.
NOTE: TO INVOKE THIS MODE, HOLD DOWN THE FOOTSWITCH MORE THAN 8
SECONDS UNTIL ALL LEDS'S STARTS FLASHING SIMULTANOUSLY. THEN RELEASE
THE FOOTSWITCH.
The Setup Wizard allows you to:
1. Decide if you want to be able to MUTE the sound (similar to a Roland US-20
device) or to be use MAX VOLUME (similar to a Roland GKP-4 device)
2. Inform the GKPX-14 how many synth units you plan to connect.
3. Selecting stomp pattern programs P1 or P2
STEP 1. Setting the GKVOL operating mode, MUTE or MAXVOL
In this the first step all four LED's are flashing GREEN or RED.
Each single-stomp toggle between these two modes:
GREEN - Select this mode if you want to be able to MUTE (*) your synths
(Roland US-20 mode)
RED
- Select this mode if you want to use MAXVOL(*) on unselected synth units
(Roland GKP-4 mode)
(*) Note: To MUTE or put the synth to MAX VOLUME, the GKVOL control must be
assigned to Patch Volume in each of the synth units. See the user's guide of the
particular synth unit.
Double-stomp to store the setting and continue with Step 2.
STEP 2. Setting the number of connected synth units.
In this step the number of LED's flashing YELLOW indicates the number of synth units
you are planning to use.
Press the footswitch to change the number of flashing YELLOW LED's (1->2->3->4-
>1->2 ... etc.) until the proper number is shown.
Double-stomp to store the setting and continue with Step 3.
GKPX-14
GK Parallel Box
9
Advertisement
Table of Contents
