Stomp Program P3 - Primova GKPX-14 User Manual

STOMP PROGRAM P3

This program allows direct toggling between the units similar to a US-20 unit.
Description of the "Morse code":
Dot ".", represents a stomp where the footswitch is held down <1.5 seconds.
Dash "-", represents a stomp where the footswitch is held down >1.5 seconds
(command executes automatically after 1.5 sec without releasing the footswitch).
If you have configured for 2 synths using the Setup Wizard:
Stomp pattern
Single-stomp
Double-stomp
If you have configured for 3 synths using the Setup Wizard:
Stomp pattern
Single-stomp
Double-stomp
Single-stomp-long
Triple-stomp
Quad-stomp
Single-stomp-long
Double-stomp-long
Triple-stomp-long
If you have configured for 4 synths using the Setup Wizard:
Stomp pattern
Single-stomp
Double-stomp
Single-stomp-long
Triple-stomp
Quad-stomp
Single-stomp-long
Double-stomp-long
Triple-stomp-long
Quad-stomp-long
GKPX-14
Morse code Action
. Toggles A or B on VOL and S1&S2
. . Enables VOL mode on BOTH
Morse code Action
. Cycle A->B->C on VOL and S1&S2
. . Enables VOL mode on all THREE
- Reverse cycle C->B->A on VOL and S1&S2
. . . Activate selected + 1
. . . . Activate selected + 2
- Cycle C->B->A on VOL and S1&S2
. - Activate selected - 1
. . - Activate selected - 2
Morse code Action
. Cycle A->B->C->D on VOL and S1&S2
. . Enables VOL mode on all FOUR
- Reverse cycle D->C->B->A on VOL and S1&S2
. . . Activate selected + 1
. . . . Activate selected + 2
- Cycle C->B->A on VOL and S1&S2
. - Activate selected - 1
. . - Activate selected - 2
. . . - Activate selected - 3
GK Parallel Box 8