GKPX-14 GK Parallel Box INTRODUCTION The GKMX-14 stomp box allows you to connected to up to four 13-pin Guitar Synthesizer units such as Roland GR-33, GR-55, VG-99, Boss GP-10 or other similar 13-pin devices. The 13-pin input is compatible with Roland GC-1 or any other 13-pin GK-3, GK-2 or GK-KIT equipped guitar.
Patch Volume. This can easily be modified in the patch setting of the synth. The GKPX-14 allows you to individually connect the GKVOL signal to any or several of the connected synth units. When this VOL connection is enabled, (indicated by the GREEN component of the LED) the guitar GK VOL knob modifies the volume/expression of the synth(s).
IF YOU HAVE ONLY TWO SYNTHS THIS PROGRAM MAY BE YOUR FAVOURITE We strongly suggest you try all programs to see which one you handle the best. NOTE: TO SELECT BETWEEN P1, P2 or P3 YOU MUST RUN THE SETUP WIZARD. GKPX-14 GK Parallel Box...
Double-stomp-long Change unit B S1/S2 mode Triple-stomp-long . . - Change unit C S1/S2 mode Quad-stomp-long . . . - Change unit D S1/S2 mode Penta-stomp-long ..- Toggle S1/S2 mode on ALL GKPX-14 GK Parallel Box...
Toggle selected unit VOL mode Double-stomp Move cursor to the next unit Double-stomp-long Move cursor to previous unit Triple-stomp . . . Make selected unit exclusive for VOL and S1/S2 Quad-stomp ..Toggle selected unit S1/S2 mode GKPX-14 GK Parallel Box...
1. Decide if you want to be able to MUTE the sound (similar to a Roland US-20 device) or to be use MAX VOLUME (similar to a Roland GKP-4 device) 2. Inform the GKPX-14 how many synth units you plan to connect. 3. Selecting stomp pattern programs P1 or P2 STEP 1.
Please try out all programs and use the one that works best for your need and taste. Complete this step with a Double-stomp and exit the Setup Wizard procedure. NOTE: WHEN SETUP IS FINALIZED YOUR SETTINGS WILL BE PERMANENTLY STORED IN FLASH MEMORY UNTIL YOU RUN THE WIZARD AGAIN. GKPX-14 GK Parallel Box...
GKD 1. Unscrew the bottom four larger Phillip screws and lift the top of. 2. Remove the jumper located underneath the board at actual GK connector. 3. Put the top and the four screws back again. GKPX-14 GK Parallel Box...
SUBSONIC FILTER (option) The GKPX-14 can be equipped with a permanently engaged Subsonic Filter Board (ordered separately). Note: This board is NOT suitable for Electric Bass or if you de- tune your guitar to below C2 on the thickest E-string.
Page 13
3. Remove to board by wiggling it upwards. 4. Underneath the board you should find a plastic bag containing 6 small 2mm jumpers (if not, please contact Primova). 5. Place the six (6) jumpers (one for each string) at the top positions of connectors.
Page 14
WARRANTY PRIMOVA AB WARRANTS THE GKPX PRODUCT FOR ONE YEAR. TWO YEARS IF INSIDE LIMITATION OF LIABILITY AND WARRANTY NO WARRANTIES OF DAMAGES TO CONNECTED EQUIPMENT OR CABLES. NO WARRANTIES IF UNSUITABLE VOLTAGE HAS BEEN APPLIED TO CONNECTORS. PRIMOVA AB ONLY WARRANTS THE GKPX UNIT ITSELF.
Need help?
Do you have a question about the GKPX-14 and is the answer not in the manual?
Questions and answers