Stomp Program P2 - Primova GKPX-14 User Manual

STOMP PROGRAM P2

This program uses a cursor (flashing LED) to highlight a unit for further action. At a
certain point in time you apply a change to the unit.
The cursor is indicated by a flashing of the LED. If any of the LED-components are ON
the cursor will DIM the led periodically but having it mostly ON.
If both of the led-components are OFF the cursor will LIGHT the LED periodically but
having it mostly OFF.
Moving the cursors does not affect any other setting such as GK VOL or S1/S2
control.
Description of the "Morse code":
Dot ".", represents a stomp where the footswitch is held down <1.5 seconds.
Dash "-", represents a stomp where the footswitch is held down >1.5 seconds
(command executes automatically after 1.5 sec without releasing the footswitch).
Stomp pattern
Single-stomp-long
Single-stomp
Double-stomp
Double-stomp-long
Triple-stomp
Quad-stomp
GKPX-14
Morse code Action
- Toggle VOL mode on ALL
. Toggle selected unit VOL mode
. . Move cursor to the next unit
. - Move cursor to previous unit
. . . Make selected unit exclusive for VOL and
S1/S2
. . . . Toggle selected unit S1/S2 mode
GK Parallel Box 7