Table of Contents
Advertisement
Professional Series
Bottom Load Cold Dispenser for
Plumbable Single Serve Brewing
System
(Shown but Not Included)
Model # 601126
TO REDUCE THE RISK OF INJURY AND PROPERTY DAMAGE, USER
MUST READ THIS MANUAL BEFORE ASSEMBLING, INSTALLING &
OPERATING DISPENSER.
SAVE THIS MANUAL FOR FUTURE USE
Notice: This product is not affiliated with or licensed by Keurig,
Incorporated or Green Mountain Coffee Roasters, Inc.
Keurig® is a registered trademark of Green Mountain Coffee
Roasters, Inc. This product does not meet Energy Star standards
for cold water dispensers.
Advertisement
Table of Contents
Related Manuals for Primo Water 601126 Professional Series
Summary of Contents for Primo Water 601126 Professional Series
- Page 1 Professional Series Bottom Load Cold Dispenser for Plumbable Single Serve Brewing System (Shown but Not Included) Model # 601126 TO REDUCE THE RISK OF INJURY AND PROPERTY DAMAGE, USER MUST READ THIS MANUAL BEFORE ASSEMBLING, INSTALLING & OPERATING DISPENSER. SAVE THIS MANUAL FOR FUTURE USE Notice: This product is not affiliated with or licensed by Keurig, Incorporated or Green Mountain Coffee Roasters, Inc.
-
Page 2: Table Of Contents
This dispenser is distributed and warranted by Primo - America’s leading supplier of water dispensers. Primo Water Corporation does not warranty or service Keurig® brewers. Notice: This product is not affiliated with or licensed by Keurig, Incorporated or Green Mountain Coffee Roasters, Inc. Keurig® is a registered trademark of Green Mountain Coffee Roasters, Inc. -
Page 3: Features And Functions
Water Bottle – Not included. Uses 3, 4 or 5 gallon round or rectangular bottles. Visit PrimoWater.com to find Primo Water at a store near you. Nightlight Switch – Flip blue control to ON to activate nightlight. -
Page 4: Warnings
If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ WARNING SAFETY PRECAUTIONS To reduce risk of injury and property damage, user must read this entire guide before assembling, installing & operating dispenser. Failure to execute the instructions in this manual can cause personal injury or property damage and may void warranty. -
Page 5: Getting Started
If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ GETTING STARTED Install Stability Base 1. Remove box from inside of cabinet. 2. Remove base halves and hardware from box. 3. Place dispenser on its side. 4. Slide both halves of base together. Connect base to bottom of dispenser using hardware provided –... -
Page 6: Using Dispenser Without Plumbable Single Serve Brewing System
If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ USING DISPENSER WITHOUT Plumbable Single Serve Brewing System Install Water Bottle 1. Open dispenser door. 2. Place probe on hanger. 3. Place fresh bottle of water outside of cabinet. 4. - Page 7 If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ Activate Nightlight Push top side of blue power switch in to turn light on. Push bottom side in to turn light off. Dispense Cold Water (37°F to 50°F) After setup, it will take up to 1 hour to get water to maximum cold temperature.
-
Page 8: Using Dispenser With Plumbable Single Serve Brewing System
If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ USING DISPENSER WITH Plumbable Single Serve Brewing System Install Brewer Notice: This dispenser has been engineered specifically for use with a Keurig® K150P Plumbable Single Serve Brewing System. Do not attempt to operate with any other model brewer. - Page 9 If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ Activate Cooling Notice: This unit will not dispense cold water until the green switch is in the ON position. To activate, push top side of green power switch in. The snowflake icon on the control panel will light up blue, indicating the unit is chilling water.
- Page 10 If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ Dispense Cold Water (37°F to 50°F) After setup, it will take up to 1 hour to get water to maximum cold temperature. During this time the compressor may run continuously. This is normal. For your convenience, this dispenser features touch control dispensing.
-
Page 11: Replacing Empty Water Bottle
If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ REPLACING EMPTY WATER BOTTLE When your bottle needs to be replaced, the empty bottle icon will flash orange to alert you. Replace with a full water bottle as soon as possible. Notice: For your safety, this dispenser is programmed to not dispense water if the indicator light is blinking. -
Page 12: Troubleshooting
If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ TROUBLESHOOTING Water is leaking. Unplug dispenser, remove bottle and call 866-429-7566 for assistance. No water is coming from the spout. Make sure the bottle is not empty. If empty, replace it. ... -
Page 13: Limited Warranty
_______________________________________________________________________________________ LIMITED WARRANTY Primo Water Corporation, (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of two (2) years from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.
Need help?
Do you have a question about the 601126 Professional Series and is the answer not in the manual?
Questions and answers
Does the primo model 601166 have a filter
The provided context does not mention a filter for the Primo Water Professional Series model 601126.
This answer is automatically generated