Do you have a question about the 601000 and is the answer not in the manual?
Questions and answers
Tim
March 23, 2025
Have model 601292. Pump working and water will come out hot side but not cold side
1 comments:
Mr. Anderson
May 14, 2025
If the cold water side is not working on the Primo Water model 601292, possible issues include:
- The unit may not have had enough time to chill the water; it takes up to one hour after setup. - The power cord may not be properly connected to a working outlet. - The green power switch on the back of the dispenser may be OFF. - The dispenser may be placed too close to a wall; ensure there is at least 4 inches of space and airflow on all sides.
If these steps do not resolve the issue, call 1-866-429-7566 for assistance.
Page 1
If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ Bottom Loading Water Dispenser Model # 601000 TO REDUCE THE RISK OF INJURY AND PROPERTY DAMAGE, USER MUST READ THIS MANUAL BEFORE ASSEMBLING, INSTALLING & OPERATING DISPENSER.
Water Bottle – Not included. Uses 3, 4 or 5 gallon bottles. Go to www.PrimoWater.com to find Primo Water at a store near you. Energy Saver Switches – Located on back of dispenser. Switch red control to off to stop heating.
IMPORTANT: Do Not Return Dispenser to Store. If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ SAFETY PRECAUTIONS To reduce risk of injury and property damage, user must read this entire guide before assembling, installing & operating dispenser. Failure to execute the instructions in this manual can cause personal injury or property damage and may void warranty.
IMPORTANT: Do Not Return Dispenser to Store. If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ GETTING STARTED To watch videos of the processes noted in this section, please visit www.primowater.com. Locate Dispenser 1. Place dispenser upright. Notice: To avoid damage to compressor, allow dispenser to sit upright at least 45 minutes before proceeding.
IMPORTANT: Do Not Return Dispenser to Store. If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ Activate Heating & Cooling Notice: This unit will not dispense hot or cold water until the switches are activated. 1. To activate, push top side of power switches in to start heating and cooling water. If you do not want to heat water, push bottom side of red switch in.
Page 6
IMPORTANT: Do Not Return Dispenser to Store. If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ After setup, hot water will be available in 15-20 minutes. Notice: Use only cups, mugs or pots that can safely contain hot water. 1.
IMPORTANT: Do Not Return Dispenser to Store. If you have questions or issues please contact 1-866-429-7566 for expert assistance. _______________________________________________________________________________________ TROUBLESHOOTING To watch a complete library of troubleshooting videos, please visit www.primowater.com. Water is leaking. Unplug dispenser, remove bottle and call 866-429-7566 for assistance. •...
_______________________________________________________________________________________ LIMITED WARRANTY Primo Water Corporation, (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of two (2) years from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.
Need help?
Do you have a question about the 601000 and is the answer not in the manual?
Questions and answers
Have model 601292. Pump working and water will come out hot side but not cold side
If the cold water side is not working on the Primo Water model 601292, possible issues include:
- The unit may not have had enough time to chill the water; it takes up to one hour after setup.
- The power cord may not be properly connected to a working outlet.
- The green power switch on the back of the dispenser may be OFF.
- The dispenser may be placed too close to a wall; ensure there is at least 4 inches of space and airflow on all sides.
If these steps do not resolve the issue, call 1-866-429-7566 for assistance.
This answer is automatically generated