Kenwood KVC-1000 Instruction Manual page 32

Installation
Connections
Audio/Visual Input or Output
•
Visual (Yellow)
•
Audio left (White)
•
Audio right (Red)
NOTE
IN-OUT setting
•Set to "IN" when using a video
player or when connecting a
navigation unit other than
Kenwood.
•Set to "OUT" when connecting to
another monitor.
Connection cable
(Provided with the KTC-1000R/A907)
KTC-1000R/A907
Connection cable
(Provided with the C907)
C907
NOTE
When the KTC-1000R is connected,
32
see the KTC-1000R Instruction
Manual
Accessory 3
M 4
NAV
IN OUT I / F
Accessory 1
Parking sensor cable (Green)
Automatic illumination control
cable (Orange)
Ignition cable (Red) ª12V
Battery cable (Yellow) ª12V
Fuse (5A)
Ground cable (Black) · (To car chassis)
MASTER SW cable (White/Red)
Kenwood navigation unit
KVC-1000
Accessory 2
PRK SW
ILLUMI
ACC
BATT
MASTER
SW
Accessory 6
2CAUTION
When disconnecting the I/F cable,
pull on the connector's ring.
To parking brake detection switch harness
of car
2 CAUTION
For the sake of safety, be sure to connect
the parking sensor.
To car headlight switch
Ignition key switch
ACC
When not connected to the KTC-1000R/A907,
this cable should be connected to ·.
2 CAUTION
The unit will not operate unless the cable is
connected.
–
+
Battery