Electrical Safety - Black & Decker Pro Line BPSJ4800 User Manual

ENGLISH
• This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety. Children should be supervised to ensure
that they do not play with the appliance.
• The intended use is described in this instruction manual.
The use of any accessory or attachment or performance
of any operation with this tool other than those
ecommended in this instruction manual may present a
risk of personal injury and/or damage to property.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must
read the instruction manual.

Electrical safety

This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features:
1. On/off switch
2. Lock-on button
3. Dust extraction outlet
4. Shoe plate
5. Saw blade support roller
6. Pendulum stroke selector
6
Fig. C
7. Saw blade storage compartment (KS702PE & KS703PE)
Assembly
Warning! Before attempting any of the following operations,
make sure that the tool is switched off and unplugged and
that the saw blade has stopped. Used saw blades may be
hot.
Fitting and removing the saw blade (fig.A )
• Loosen (do not remove) the two screws (11).
• Hold the saw blade (8) with the teeth facing forward.
• Insert the shank of the saw blade (8) into the blade holder
(10) as far as it will go.
• Slightly tighten the two screws (11) alternately to position
the blade, then fully tighten the two screws (11).
• To remove the saw blade (8), turn both screws (11) one
turn counter-clockwise.
Connecting a vacuum cleaner to the tool (fig. B)
An adaptor (12) is required to connect a vacuum cleaner or
dust extractor to the tool. The adaptor can be purchased from
your local Black & Decker retailer.
• Push the adaptor (12) into the dust extraction outlet (3).
• Connect the vacuum cleaner hose (13) to the adaptor
(12).
Saw blade storage (KS702PE & KS703PE only) (fig. C)
Saw blades (8) can be stored in the storage compartment (7)
located on the side of the tool
• Open the cover of the saw blade storage compartment
(7) by holding the tab on the top of the door and pulling
outwards.
• Remove or store saw blades (8) in the storage
compartment. (7).