Black & Decker BDCF18 User Manual


Quick Links


Table of Contents

Summary of Contents for Black & Decker BDCF18

  • Page 3: Safety Instructions

    (Original instructions) ENGLISH Intended use f. If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of Your BLACK+DECKER torch has been designed for providing electric shock.
  • Page 4: Residual Risks

    ENGLISH (Original instructions) Additional power tool safety warnings d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power Warning! Additional safety warnings for torches tools are dangerous in the hands of untrained users.
  • Page 5 (Original instructions) ENGLISH Labels on tool Electrical safety The following pictograms are shown on the tool: Your charger is double insulated; therefore no Warning! Read all safety warnings and all earth wire is required. Always check that the instructions. Failure to follow the warnings and mains voltage corresponds to the voltage on the instructions listed below may result in electric rating plate.
  • Page 6: Maintenance

    ENGLISH (Original instructions) Note: It may take as long as 60 minutes to determine that the battery is defective. If the battery is too hot or too Warning! Let the tool work at its own pace. Do not overload. cold, the LED will alternately blink red, fast and slow, one Switching on and off To switch the torch on press in the switch (1) To switch the torch off press in the switch (1)
  • Page 7: Technical Data

    Run the battery down completely, then remove it from the tool. NiCd, NiMH and Li-Ion batteries are recyclable. Take them to any authorised repair agent or a local recycling station. Technical data BDCF18 (H1) Voltage...
  • Page 8 Australia & New Zealand Stanley Black & Decker Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) 90620261 01/2014...

Table of Contents