Advertisement
Too much air pressure and unclean air will shorten the product life due to excessive wear, and may cause
damage and/or personal injury.
1. Make sure that the air valve (or trigger) is in the "off" position before connecting to the air
supply.
2. An air pressure of 90 PSI is required.
3. Drain the air tank daily. Water in the airline can damage the tool.
4. Clean the air inlet filter weekly.
5. Line pressure should be increased to compensate for longer air hoses (over 26 feet or 8
meters). The hose diameter should be 3/8in. I.D.
6. Keep the hose away from heat, oil and sharp edges. Check the hose for wear and make
certain that all connections are secure.
WARNING: Make sure the 2-in-1 Angle Grinder and Cutoff Tool is disconnected from its power
source before attempting any maintenance, cleaning, or inspection.
·
Maintain your 2-in-1 Angle Grinder and Cutoff Tool. It is recommended that the general condition of any
tool be examined before it is used. Keep your 2-in-1 Angle Grinder and Cutoff Tool in good repair by
adopting a program of conscientious repair and maintenance in accordance with the recommended
procedures found in this manual. If any abnormal vibrations or noise occurs, turn the 2-in-1 Angle
Grinder and Cutoff Tool off immediately and have the problem corrected before further use. Have
necessary repairs made by qualified service personnel.
·
Keep all cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control. Keep handles dry, clean, and free from oil and grease.
·
Cleaning. Use only soap and a damp cloth to clean your 2-in-1 Angle Grinder and Cutoff Tool. Many
household cleaners are harmful to plastics and other insulation. Never let liquid get inside the 2-in-1
Angle Grinder and Cutoff Tool.
MAINTENANCE
5 OF 7
Advertisement
