Advertisement
Quick Links
REPLACEMENT PARTS
1/4in. Air Angle Grinder
# 29155
OWNER'S MANUAL
SPECIFICATIONS:
Collet.............................................................................................................................1/4in.
Recommended air pressure(tool in use at full throttle) ....................................................90 PSI
Average air consumption.............................................................................................4.0 CFM
Free speed ............................................................................................................20000 RPM
Air inlet..........................................................................................................................1/4in.
Recommended hose size............................................................................................3/8in. ID
Specifications are subject to change without notice.
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO SO
MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
Distributed by Northern Tool & Equipment Co., Inc.
Burnsville, MN 55306 NorthernTool.com
Made in China
Advertisement
Related Manuals for Klutch 29155
Summary of Contents for Klutch 29155
- Page 1 REPLACEMENT PARTS 1/4in. Air Angle Grinder # 29155 OWNER’S MANUAL SPECIFICATIONS: Collet..........................1/4in. Recommended air pressure(tool in use at full throttle) ............90 PSI Average air consumption.....................4.0 CFM Free speed ......................20000 RPM Air inlet..........................1/4in. Recommended hose size....................3/8in. ID Specifications are subject to change without notice.
- Page 2 IMPORTANT SAFETY INFORMATION AIR SOURCE 1.Always use approved eye and ear protection when using air powered tools. If Clean air and correct air pressure is recommended for the power supply for this tool. A raising dust/debris,wear a suitable mask. do not wear loose clothing or jewelry. maximum of 90 PSI at the tool is recommended for most air tools of this class.