For Network Users; Web Based Management; Web Browser - Brother DCP-9270CDN Quick Setup Manual

For Network Users

Web Based Management

(web browser)

The Brother print server is equipped with a web server
that allows you to monitor its status or change some
of its configuration settings, using HTTP (Hyper Text
Transfer Protocol).
Note
• The default User Name is 'admin' and the
default password is 'access'. You can use a
web browser to change this password.
• We recommend Microsoft
®
Explorer 6.0 (or greater) or Firefox 3.0 (or
®
greater) for Windows
greater) for Macintosh. Please also make sure
that JavaScript and cookies are always enabled
in whichever browser you use. To use a web
browser, you will need to know the IP address
of the print server. The IP address of the print
server is listed on the Network Configuration
List.
a
Open your browser.
b
Type "http://machine's IP address/" into your
browser's address bar (where "machine's IP
address" is the IP address of the printer or the
print server name).
 For example: http://192.168.1.2/
See Web Based Management in the Network
User's Guide.
®
Internet
and Safari 3.0 (or
Print the Network Configuration
List
You can print the Network Configuration List to
confirm the current network settings.
a
Turn on the machine and wait until the machine
is in the Ready state.
b
Press MENU.
c
Press a or b to display Print Reports.
Press Print Reports.
d
Press Network Config.
e
Press Mono Start or Colour Start.
The machine will print the current network
settings.
Restore the network settings to
factory default
To restore all network settings of the internal
Print/Scan server to factory default, please follow the
steps below.
a
Make sure the machine is not operating, then
disconnect all the cables from the machine
(except the power cord).
b
Press MENU.
c
Press a or b to display Network.
Press Network.
d
Press Network Reset.
e
Press Yes.
f
Press Yes for 2 seconds.
The machine will restart, re-connect cables
once this is complete.
17