Overview And Site Preparation - Kenmore 625.38156 Owner's Manual

OVERVIEW
There are seven easy steps to installing your Drinking
Water system. They are as follows:
STEP 1 - install Cold Water Supply fitting
STEP
STEP
STEP
STEP
STEP
STEP
2 - install Drain Adapter
3 - install Reverse Osmosis Assembly
4 - install Storage Tank
5 - install Reverse Osmosis Faucet
6 - Connect Tubing
7 - Sanitize, Pressure Test, Purge System
These steps are explained in detail over the next few
pages.
it is recommended to read through the entire manual
before beginning your installation. Follow all steps exact-
ly. Reading this manual will also help you receive and
use all the benefits your Reverse Osmosis System can
give you.
Figure 4
PREPARE SITE FOR INSTALLATION
1. Before starting, close the hot and cold water shutoff
valves (See Figure 5).
2. Temporarily place tank and filter assembly into cabi-
net. Double check position of items and space required
for proper installation.
3. Remove tank and filter from cabinet and set aside.
NOTE: You must check and comply with all local
plumbing codes.
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com